you need
  • - board thickness 50 mm;
  • - die thickness of 30-40 mm;
  • - casein glue;
  • - aspen board;
  • - Circular Saw;
  • - plane;
  • - oil varnish;
  • - bolts;
  • - Drill;
  • - sandpaper;
  • - a container of water.
Guide
1
First, fabricate mold to ensure proper bend.To do this, take a wide flat board without cracking a thickness of 50 mm.Otstrogayte her and lay on top of a stick factory manufacturing - the sample.
2
Prepare a few short dies of birch bar thickness of 35-40 mm, otstrogayte one side (to be in).Glue on the inner contour of the die stick firmly, and on the outside - step back from the 4-5 cm.
3
When the glue is dry, drill dies together with the board through a thin drill, and further tighten the screws, ensuring uni
formvery firmly established dice on the board.As a result, you should get a pretty broad form putter .
4
Prepare Rails putter .Take aspen boards, not rotten and without knots.Aspen is best suited as durable and lightweight, and well bent.Use the circular saw to saw a few strips of thickness 7-8 mm.Reiki must be a very smooth surface without needing additional planing.
5
Tie rack in a bunch, tie them load and lower in the water for a week.During this time, they swell and are easy to bend.
6
When the rack is enough melted, remove them and place in a mold, pressed tightly to the inner side.On the outside of the space will remain - hammer it between strips and wedges dies to blank sat very tight.
7
design Keep warm for 10-14 days.Do not forget to tamp wedges through the day as drying rack give them slack.Finally, the dried slats take shape.
8
Place on mold film to not mess it with glue.Coat rack casein glue and then put them into the form, put in a warm place for two days.
9
Dried workpiece treat a plane, saw off all unnecessary jigsaw.Sand homemade stick and coat with varnish.The handle and the lower part can wrap additional tape cloth to improve performance.