Tip 1: How to connect ovens and cooktops

modern hob, or as it is called "hob" - a special modification of the electrical plates, designed to maximize comfort and harmony with modern kitchen design solution.To put it simply, the cooktops and built-in electric oven - it's the same electric only divided into two parts.
Guide
1
before taking connecting the oven and cooktop, please read the specifications and key design features.
2
are two types of cooking surfaces:

- related, which is controlled by an electric oven placed on the arms,

- not related, which is equipped with a separate power supply and its own management.
3
Analyze electricity cuisine, its capacity should be sufficient to connect the devices and be autonomous.If the voltage is not the same as required, you will need an additional cable connection hoses.
4
when installing wiring for the electric oven and hob, use consumables, taking into account the fact that the oven is calculated (average) power consumption 2-3kVt and cooktop will consume up to 7kW.
Therefore, to ensure complete safety during the subsequent operation of the instrument, lay electric wire cross section of at least 4mm for the cooktop and oven 1-2,5mm.
5
Compulsory make a grounding devices that will guarantee a secure, stable and uninterrupted operation.
6
Typically, hob, unlike electric oven designed for 1-2-3-phase electrical connection, due to the high energopotreblyaemostyu panel.So, read the nameplate data before installation of both devices, as the electrical characteristics depend on the power of their class.
7
unrelated cover and connect the oven at various pre-installed outlet.

Tip 2: How to connect an electric hob

Stove Electrical panel usually much more powerful electric oven, so before you connect it to a conventional wall outlet, be sure to check the wiring and replace it if necessary.
How to connect an electric hob
Guide
1
Check whether copper cables or not, and which has a section (using a cable with a cross section of not less than 6 sq. Mm).Face the machine should not be less than 50A.
2
Remember when installing the boards in any case requires a separate power cable.Pick up a three-wire cable, cross-section of at least 4 square meters.mm, and attention to the three-pin outlet.Find out on what effect the current it is designed (must be between 15 and 30A).Installation of a separate electric line (cable PVS3h1,5) produce straight from the board with machine guns, set at one end of the socket with earth contact, and on the other - machine 16A.
3
For electrical installation, only use reliable equipment and high quality materials known manufacturers from wires, ducts and outlets to the switchboards.
4
If you do not have specialized knowledge on the installation power socket outlets, electrical cable, use the services of a specialist.
5
After preparing the electric line unpack elektrovarochnuyu panel and make the appearance inspection for mechanical damage during transport, prepare it for operation.Remove the old device, if required.Check all previously assembled and compounds on the panel for a short circuit.Install the unit in place for further use.To avoid pouring cooking food, the installation is complete in terms of alignment panel.
6
Test elektrovarochnuyu cover for the absence of defects in factory working conditions.Before installing and operating panel is required to read the manual and pay attention to point to assure its efficiency in self-assembly and installation specialists qualified retailer or service center.If necessary, receive additional information on installing and operating the unit specially indicated for this phone.
Helpful Hint
1. hob and oven are vstraevyemymi devices.Location quiet location is determined in advance when ordering kitchen furniture.
2. If necessary equipment can be installed in an existing set.To do this, cut a hole in the worktop that corresponds to the area of ​​the hob and the oven is placed in the cabinet to remove doors and rear wall.Thus it is not a related oven may be arranged as a heating surface, and in any other convenient location.
Installing the kitchen hood with his hands
Related article
Installing the kitchen hood with his hands
Sources:
  • connection hob and oven

0
0