- - mounting kit;
- - Drill;
- - level;
- - Roulette;
- - marker.
Screw hexagon, which is included in the mounting kit railing, a small cog in the body of the railing so that the rails on the holder to move freely.At the base of the screw in the second screw so that it is freely worn on the sleeve, which is mounted on the wall of a screw.Screw cogs all holders, two for the holder in the same manner.
Insert roof rails in the brackets and tighten the screws that hold the roof rails in the holder.When mounting the screws should not be noticeable, i.e.place them at the bottom.It is necessary to take into account a number of points before the holders are permanently fixed to the roof rail, and you proceed to markup.On the edge of the railing will be wearing a cap, the hoo
ks can not dress for the rails on after, and during the installation of railing, the joints railings must stay inside the holder, in the event that an integral roof rails or kitchen corner.In accordance with this, determine the location of the holder in the roof rail.Tighten the tube holders on the railing.
railing Determine the distance from the countertop so that it was convenient to place utensils.Circle the extreme base of the pencil or marker.Drill a hole in the wall or if the wall panel is installed, first go to her, and then drill into the wall in concrete with a diameter of 6 mm.In the opening drive in the dowel.Screw the screw holder sleeve.
extreme Put holder on sleeve.The second end of railing is free.Using a ruler or tape measure, set parallel to the rails on top.In this position, the next holder circle.Drill the next hole, and so on, setting the holder in place.
Screws used in attaching very small and made of soft metal.They require very careful treatment.
Look closely at the sleeve before it prikrepit.Opredelite that her direction, which should be placed against the wall.