- - acetic acid;
- - baking soda;
- - red brick;
- - tooth powder;
- - GOI paste;
- - citric acid.
dark thin film covering with time copper samovars , is a product of the oxidation of copper.Getting rid of it is not easy, but it vozmozhno.Naleyte in the samovar boiling water or, if acting samovar, heat the water in it.Prepare a solution of acetic acid (5-10%) and clean them hot samovar.This method is the safest for the samovar, as it does not hurt, it does not scratch.
Use baking soda.Dampen a soft cloth tissue in warm water, apply a small amount of baking soda on it.Wipe the surface of the darkened
samovar slowly, lightly.Do not press down on the cloth, do not put more effort, otherwise you will damage the samovar, leaving it stains and minor scratches.
Follow the example of their ancestors - for cleaning the samovar, use finely crushed brick.The smaller, the better.Note that this method is very traumatic for the old copper water heating appliance.The same principle can be used ordinary sand.
Clear samovar help and tooth powder.Use it for example baking soda - on a soft cloth, apply a little powder and gently rub the surface.
use special means for cleaning copper - Paste GOI on the basis of chromium oxide, which is designed for grinding and polishing metals and others.
If cleaning is required for the inner surface of the samovar, then apply the following method: boil the samovar with water, adding a citric acid (for simple dirt 5 g per 10 liters of strong scale - 40 gramsthe same volume of liquid).After this procedure, be sure to rinse the samovar to exclude poisoning.
Last method of purification for the lazy, or for those who cherish the old samovar.Just take it to the professionals who have a variety of chemicals to work with rarity things.They certainly will not damage the surface of the samovar and return it to you updated.
Tip 2: How to Clean the samovar
believed that this samovar able to fill the house of the Russian spirit and celebration.However, if you bought this unit with hands before use should be subjected to "pot-bellied" thorough cleaning.How to do it most effectively and easily, should tell us more.
Disassemble samovar .Typically, removable parts from them is not enough: the key and tap on it stand and possibly handle and crown.In most cases, the list will be filled only halfway.
Fill samovar water.For starters, you can use ordinary water from the tap, pre-plugged hole for the faucet.Make sure samovar does not leak and has no holes.If these are all the same, or repaint them soldered a small piece of aluminum, or by using a special liquid rubber.
Begin the bulk of bathing after samovar be patched.To get started is to wash the inside.Fill the flask with hot water unit is first mixed with detergent.You can use a regular sponge, if the hole in the lid wide enough to hand it climbed.If this is not possible, buy a new brush or a special brush.
After samovar be completely cleared, it should again fill it with water and disinfectants.At a minimum, place a solution of potassium permanganate average concentration.Rinse the flask properly again, and then proceed to the next step.
Clean the outer part of the samovar and detergent, as we did inside.Cleaning the outside only difference is that you do not need to disinfect it here, but be careful with those areas where the joint parts.As a rule, the "age" takes its over samovar th in these places, and too careful and active cleaning can damage the body and create new cracks.
Collect samovar after treatment, and at least twice boil water in it before tea - is a necessary measure to kill the remnants of bacteria and lead, may not be flushed cleaners, which can bemore dangerous than even the bacteria.
- copper samovar price