Tip 1: How to build a toilet with his hands

in the country or in the yard of a private house toilet on the street is a must.Spending a small amount of effort, time and building materials, you can easily build it yourself.From wells and drinking wells toilet should be located at a distance of 30-50 meters.Taken into account the depth of the water table.If they are above 2.5 meters, then toilet and must be equipped with the capacity and as clean fill.When the depth of groundwater is less than 2,5 meters can dig a cesspool.
you need
  • -plotnitskie tools
  • -tes
  • -brus or poles
  • -Material for roofing (iron, slate, roofing material)
  • -Material for plating sump
  • -gvozdi orscrews
Guide
1
Dig cesspool.Dig it can be manually or bucket of the tractor.The pit should be deep enough to toilet served more than one year.If you
soil prone to obsypaniya, the bottom of the sump and the sides need to cement.To do this, the formwork and pour cement mortar.You can sheathe the right side or slate boards.
2
over the cesspool put a stur
dy floor.It can be made of beams, logs or thick iron pipes.
3
Make frame for and toilet.For this wooden posts dug previously to isolate them from the ground.The height and width to length do you want.The rear of the pillars were shorter than the front.To the roof dripping rainwater.
4
the bottom of the frame nail boards. installing a toilet on the floor it is necessary to prikopat he stood firmly and steadily.
5
Obsheyte frame with planks.Tes is better to take the grooved, to avoid cracks.If you take the TEC without grooves, the boards joints obsheyte further.
6
Sheathing roof release mec back and forth.To was visor and rear rainwater flowed as far as possible from the toilet well.Cover the roof with roofing material, slate and iron.
7
Spread the floor.It should be vented.The size of the hole cut at your convenience.
8
Hang the door.Screw her pen.All toilet ready.

Tip 2: How to build a toilet at the cottage

What you need to take care of first, if you just bought a plot cottage, which still do not have any buildings?That's right, on the toilet.Why would you need to celebrate in the bushes.

In general, it now goes about how you can build a cottage suite, having at itself is quite a standard set of tools and materials.
Without the toilet does not do any one party Cottage
you need
  • - a bar 100x100 mm and 50x50 mm
  • - chipboard or plywood
  • - Planer
  • - screwdriver or a screwdriver
  • - hammer
  • - hacksaw on wood
  • - screws and nails 40 mm 80 mm
  • - a sheet of slate or galvanized iron
  • - foam sheet
Guide
1
Before the construction of the toilet, you need to decide on the issue of dredging.The type of soil depends on the time, spending on its recovery.Depending on the type of soil can vary somewhat set of tools used to dig a cesspool.This is the hole should be deep enough.
2
With cesspool finished.Let's take the bar section 100 to 100 mm and a length of about 3 meters and make it a holiday frame of our toilet.A bar section 50x50 we use to manufacture seats.
3
Define some dimensions toilet.Take length 150 cm, width - 100 cm height - 210 cm. Sawn boards in dimensions and vpoldereva connect them.Thus, we get 50-50.If necessary, remove connections and irregularities otshlifuem surface.Verify using diagonal thread kapron.
4
measured from the floor 50 cm and 50x50 boards embedding in the carrier board.From the same timber will do the jumper at a distance of about 100 cm from the rear wall along the length.And on the back wall is empty exactly the same jumper.These jumpers will be the basis for the structure of our seats.
5
Now take a sheet of chipboard or plywood and cut the size of the toilet seat in its opening.Screw the plate to the jumpers screws using a screwdriver or a screwdriver.Then we need to stick to the walls of the foam and to sheathe their plywood or chipboard.About sex, too, do not forget.
6
We have to turn the roof.We will cut the transverse boards and attach them to the walls.On the boards we put a sheet of galvanized iron or wave slate, which will need to be strengthened.
7
give our toilet sustainability.For this purpose it will need to be sunk into the ground.Recall that we have on a piece of timber was 90 100x100 cm. It will be the basis for the piles.To beam easily entered into the ground, bury first hollow metal tube.After that bar goes into the ground, like butter smeared.In this work for the construction of suburban toilet can be considered finished.
Sources:
  • how to build with their own hands the toilet

0
0