Tip 1: How to pull Rabitz

fence built of mesh netting, is one of the most popular types of fences suburban areas.And this is understandable.This material is practical, reliable, affordable and easy to install.How to pull yourself mesh netting ?
you need
  • - mesh netting;
  • - metal or wooden poles;
  • - metal cable;
  • - wooden pegs;
  • - cord;
  • - rubble;
  • - sand;
  • - shovel;
  • - nails or staples;
  • - a hammer;
  • - metal hooks or clamps
  • - welder
Guide
1
Measure the border area and count the number of consumables.For this it is necessary to drive pegs at the corners of the plot and pull on them around the perimeter, the cord.Measure the length of the cord - it will meet the required length mesh netting.Calculate the required number of columns based on the fact that they must be installed at intervals of 2.5-3 meters.
2
Select mesh netting .It should be noted that the width of the grid must correspond to the desired height of the fence.To install a temporary fence will suit black wire mesh.Its price is much lower
.But if the design will be used for a long time - you need to buy a more expensive option otsinkovannanny.A fence made of such material can last more than 20 years.
3
Set poles.To do this, dig a hole depth of one meter.Sprinkle crushed stone and sand on the bottom of the pits and tamp thoroughly.Install posts and fill the hole with soil, tamping it.
4
Place the roll of mesh netting around the corner post and secure it with the edge.If you have purchased non-galvanized mesh - lift the edge of 5-10 cm above ground level.In order to securely hold the mesh on metal pillars it is recommended to weld them hooks.Another method of attachment - the use of special clamps for pipes.Of course, you can do much easier and tie the net to the posts with wire, but this option is far less attachment nadezhen.Prikrepit net to wooden poles is possible by means of special staples or nails.
5
Carefully unroll a roll, pulling the net , and attach it to the next post.Pull the metal cable in the bottom and top of the net and secure it to the ends of the poles.This technique avoids slack mesh netting.Make a fence around the perimeter of the site, using the same method.

Tip 2: How to pull netting

Mesh netting used for fencing suburban areas, private estates and poultry houses.Its use can significantly reduce the cost of the fence sections.Also, mesh-netting valued for a long service life and ease of installation, which can be done as soon as possible, with only one assistant to precisely set the poles and stretch mesh.

How to pull the netting
you need
  • - poles;
  • - solution or gravel and sand;
  • - spade or auger;
  • - mesh-netting;
  • - Area, wooden slats or wire;
  • - fixing or nails;
  • - hammer, pliers;
  • - paint;
  • - mastic;
  • - waste oil and roofing material.
Guide
1
Prepare holes for pillars.You can them dig or drill.Install metal or wooden poles.Each pillar insert into the prepared hole, fill with cement mortar or ramming using gravel and sand.Check the evenness of the installation of plumb.
2
Install posts at a distance of no more than 4-5 meters.The best option - is to set the length of the poles 3-4 roll grid, it was not necessary to disconnect.So if you bought a 10 meter rolls, place the poles at a distance of 5 meters;If the roll is 12 meter, install poles at a distance of 4 meters.
3
Attach the edge of the grid to the post.If you put a wooden support, then it is not difficult to do ordinary nails.If iron poles before attaching the mesh, weld special attachment for which you fasten it.You can also attach a mesh-wire netting, but this option is less reliable.
4
Top mesh attach to a wooden crate, a corner, or simply strengthen the wire.If you want to make a long-lasting barrier, set the iron poles, Weld area above and below, as well as mounting tabs.Stretch mesh and attach with wire.
5
Color poles and cross.If you purchased the galvanized grid, it is also better to paint.This fence will stand at least 15-20 years and do not need to repair the fence.
6
If you put the wooden pillars, insulate the bottom, which will be located in the ground from moisture and decay.You can do this by using mastic or obmazhte poles used oil and wrap with roofing material.
7
If you set the poles and some have not calculated the length of the grid, it is easy to reduce or extend.To do this, simply unscrew the desired stitch or woven into the desired length in the last line.
8
To set a goal of grid-netting make a crate of wood or corner, fix the net, weld or screw the hinges to the pillars, and to crate a loop and hang the gate.
Sources:
  • how to fix the netting
Sources:
  • Ā«make yourself to home and garden" VMSafronenko, Phoenix 2003
  • How to fence section of the fence Rabitz

0
0