Tip 1: How to make a spinning

Any angler will sooner or later want to fish on spinning .Beginners do not just go to the store becauseGood gear is serious money, it is better to try to make spinning himself.
Guide
1
Buy a specialized fishing shop coil, the best of stainless steel, as well as form a rod, as spinning will be better and you will last much longer if the parts are new.When buying, you should start from these calculations: spinning have a length of about 2.75 meters, must comply with the form of 4 m.
2
find at home a few old corks from bottles ofchampagne.You'll need to make a handle for spinning well.Cut off from them all the tabs and drill a hole in the middle.Then smear glue the part of the rod, which acts as a handle, and put it on top of the cork.If needed, a trim them so that there are no gaps.Leave a pen for some time, allowing it to dry.
3
felt every part of the rods for the presence there of the seam.At the same time your attention should be focused primarily to thickened end in a
certain place where you will notice a seal.Actually this is the seam that you are looking for.Attach directly opposite the seam reel, using a nylon thread glue.If you want to keep the cavity from moisture, insert the butt plug.
4
Designate a place for the choke, which will serve as your starting point when you begin to attach the rest of the ring.You should also be sure to pay attention to the fact that each successive ring of flow necessary to have a certain bias, but not at the same distance.And the closer you get to the choku, the offset should be increased.Attach the crossing of the ring opposite the weld rod.It should not tighten them too much thread, because of the large number of turns of the top of the knee may even break.

Tip 2: How to equip a spinning

Fishing Spinning - one way of dynamic fishing.Most often used for spinning catching predatory fish, so this gear should be well equipped to avoid losing a large trophy fish.
How to equip a spinning
you need
  • - spinning;
  • - coil;
  • - fishing line or cord;
  • - Georgia;
  • - bait.
Guide
1
Before equip spinning, you need to decide on what kind of fish you go "quiet hunt".It depends on the type of fish the choice of both the spinning and equipment for fishing.For example, to catch deep-water walleye pike or large need robust thick spinning with a cord and a large coil with a good clutch.For perch or chub need a little sensitive spinning class "ultralight" to feel the bite of small predators.This fishing reel can be mounted is not particularly powerful, because the work in the clutch Okuneva fishing is not needed.On this basis, it is better to have in your arsenal are several different characteristics spinning and equip them for a specific place and fish.
2
So, after you have decided where and for what fish you go, proceed to snap.

First you need to collect the coil if it is not collected.Tighten all connections and tie your chosen fishing line or cord ordinary node.Then wrap the fishing line on the spool.Please note that the scaffold was a sufficient number to make long-range casting, but at the same time make sure that the winding fishing line does not extend beyond the coil.Otherwise, the formation of "beards".
3
should then be collected spinning (if folding) so that the spinning rings arranged in a straight line.Then you need to fix it reel.
4
After the coil is fixed firmly and steadily, you prodernut twine or cord through the rings.Then snap depends on what kind of bait you are fishing.If it's easy twister - the need to fix the sinker.If you already use a heavy bait, such kastmaster, the more ogruzki not required.
5
If you plan to fish for pike or walleye, you need to hook bait on a firm leash, better metal (titanium) that the fish do not bite to eat when playing the line.Then the leash must be tied to the main line, spinning and ready to use.
Helpful Hint
Take a few fishing lures in the event of breakage or toe.

0
0