you need
  • Henna Body, glass cup, wooden shovel, ground coffee, black tea, lemon essential oil of eucalyptus or lavender, sugar, toothpicks, cotton swabs, syringe package olive oil.
Guide
1
easiest to use ready-made henna dye in special tubes.These tubes are sold in specialty stores and on the Internet.But it is better to use a freshly prepared pasta.
2
for Henna body painting Henna different from that color hair.It is prepared from the upper leaves of the bush Lawson gives vibrant colors and finer.Make sure you are using henna for body painting.You will need 40-50 grams of henna.Sift the henna powder through a fine sieve 2-3, it should have the consistency of powder.Henna can not cook in a
metal dish, so keep the powder in a glass or ceramic bowl.
3
Boil 0.5 liters of water, add the 2 teaspoons of ground coffee or black tea.Boil the broth over low heat or water bath for about an hour.Do not forget to stir constantly.Then strain the broth through several layers of cheesecloth.
4
hot broth pour small amounts in a cup of henna powder.Carefully rub and mix with wooden or glass spatula to avoid lumps.And do not pour all the broth, you can get too liquid paste.This paste will not stay on the skin and spoil the drawing streaks and stains.
5
in the finished pasta add a teaspoon of lemon juice or lime juice, a teaspoon of sugar and a few drops of essential oil of lavender or eucalyptus.You should get a plastic, homogeneous mass with the consistency of toothpaste.
6
Cover the container with pasta with cling film and leave in a warm place for 6 hours.During this time, be freed of powder active colorant.
7
Now prepare the skin for printing.Better to do hair removal in those areas where you are going to make a drawing.The fact that the tiny hairs are stained more intensely than the skin and the paint is kept in the balance for much longer.Also, the skin should be washed thoroughly with soap and water, and areas with a rough skin exfoliating process.After a shower, do not apply moisturizer to the body, the skin should be completely clean.
8
paste is applied to the skin brushes, wooden sticks or syringe package.If you do not have a special syringe to paint, do it from the usual dense plastic bag.Take sack bag, seal the seams with tape, paste fill two-thirds.Fold the top edge of the package and also seal the tape.You should get a small cone.At the bottom of the cone hole puncture needle.Practice apply paint on a white sheet of paper, in order to understand with what force to squeeze out the paste on the skin.
9
Apply to the prepared skin pattern of the future pattern.This can be done with a pencil to tattooing.There are also special paper stencils with holes.Lightly place the figure with olive oil, it will make the color of the picture brighter and will not give the paste to dry quickly.
10
Apply a paste of the package on the circuit pattern or randomly.Squeeze henna evenly, gently, if the opening package beating lump henna or air - clean it with a needle.If you accidentally spoil image - erase paste wet swab, a toothpick or a cotton swab and repeat again.From time to time moisten drawing solution of lemon juice and sugar.Gently moisten a wet cotton swab, but try not to grease the finished drawing.
11
Dry drawing.You can supplement the drying influence of infrared lamp bulb Minin with blue or hairdryer.The longer you keep the paste on the skin, the brighter the image.After 5-6 hours, remove the residue with a brush from the skin.Wipe your skin with almond or olive oil, it will give the color depth of the picture.