Carefully divide the hair into 5 groups: the zone of bangs, two occipital temporal area and two on each side of the head.Secure them with special pins, clamps.
Start a haircut from one of the occipital zones better with the one closest to you.Pull your hair up toward you, and then align the edges.The bottom strand in this case will act as the basis for follow-up, and on it you'll cut the rest in the area.
To cut all the subsequent strands occipital areas should be on the radial partings, pulling them to the main strands so a
s to create the elongation on the face.Try to keep straight scissors to trim the hair was neat.
start clipping the hair of the temporal area, pull them to the center parting and cut the right angle, pulling them towards the top of the head.It should be guided by the length defined previously and continue to build on the extension of the person.Unnecessary long strands can also be removed with the help of hairpins.After shearing comb the hair comb better with small teeth, it will allow you to carefully calibrated shortcomings and correct them in time.
strand in the area cut the bangs and at right angles.Try to do it as smoothly and gently, focusing on the right to this type of face shape bangs.If the fringe is not required, skip this step.
Then all the central part of the hair by radial partings to tighten control locks and trim them.
Finally haircut then align it with the Poynting and slicing techniques when special scissors with blades is uneven edge trim to the edge of the ladder were not sharp and clear.This creates a smooth transition from one level to another and adds volume to hair.Once again carefully comb the hair.
Make styling with a hair dryer and a round brush to create the desired amount of hair.Twisting the ends in this case may be both the inner side and to the outside.Shake your head after drying to hair lay in a natural way.
Tip 2: How to make a ladder
ladder in the garden or in the country, you can make yourself, you only need to know how to do it and what materials will be needed.Many irregularities specifically preserve the landscape to decorate the staircase area of the site.
Please note that the number of steps depends on the height of the stairs.The ideal height - about 14-15 centimeters and the depth - 33-35 centimeters.The width of the ladder should be at least 80 centimeters, and that on it can freely go past two persons, it should be increased to 120 centimeters.
Draw a diagram, which will cause all the dimensions that you have done on the ground (the height and length of the lift).With it will be easier to calculate the number of steps of your ladder.
You also need to choose the material of which will be made and a staircase.Natural stone (basalt or granite), waterproof and durable.Stairs made of such a material will always look good.Limestone and sandstone are less durable, so they need to be treated with a special water-repellent composition.
good option is concrete.It is durable, has a variety of colors and can withstand heavy loads.If you prefer a tree, select hardwoods such as oak.The boards should be thick enough so that the ladder was sturdy.Pre-wood to be treated by impregnation mold and mildew that lasts a long time.
Concrete tile or natural stone lay on the bedding layer having a thickness of 15-20 centimeters.Manufacture from mixture of sand and cement in a ratio of 10: 1.Ram podsypku, and the top three to five centimeters align.Stone elements and paving Lay side, otherwise you can damage the foundation.
Curbs install optional, if your ladder is not subjected to strong physical stress.Just create Berezhok, which is a wide area of the poured concrete, on which the two or three outer row of stones or pavers.
Try to control the angle and width of the surface of the steps.All gaps between the individual parts is filled with dry sand.If your staircase is made of clinker brick, put it on the same podsypku that and stones.
- Making the garden stairs
- how to cut hair ladder video