- Superglue, "Moment" or any other that glues plastic clamps small, flexible neon cord 9V and 3m, in fact, the keyboard.
Note that the flexible neon strongly buzzing.This may bother some users.Although, if your computer has more than one fan, the neon buzz will not irritate.In addition, the noise depends on the voltage neon (more power - more noise).We will take in the neon 9B.
Our main task will be the laying of the flexible neon in between the keyboard keys, the entire keyboard so he skirted along the contour.At least most of the keyboard neon in this case will illuminate.
Before routing "backlight" peel back from the edge of the keyboard cover on the back side.It must be done in the place where neon.If we do not take care of this in advance, key
board cover snaps into place.
now proceed to the laying of the flexible neon cord.Therein it should stick to the board by adhesive.Suffice it to do a few buttons.
After laying neon drill holes on the back side of our keyboard to bring out the power cord "illumination."If the keyboard reverse side is concave, there can be placed an inverter or battery pack to power the neon cord.A wire can be lengthened and connected to a conductor of our keyboard, a feeder element set anywhere within the system unit.
inverter allows battery-powered neon work from the usual 9-tivoltovoy batteries.If there are no batteries or hunting change them, you can do a transformer, which is connected to a specific port in the inverter at one end, and the other usual outlets.The transformer can be purchased on the radio market or thrift shop.It will allow us to choose from several voltage values, beginning and ending with 3B 12V.So we can adjust the brightness of neon and noise.Switching voltage is possible even when the neon works.The kit together with the transformer should include multiple plugs for different types of outlets.Choosing the right fork and enjoy the beautiful lighting.
Tip 2: How to make a wireless keyboard
make wireless keyboard from the wire in varying ways, however, it will require a great deal of patience from you, a great interest in radio and programming skills.If you really need a wireless keyboard in a working condition, it is best to use the resetting device of reception and transmission signal with unnecessary wireless device model.
- - optional wireless keyboard;
- - IR transmitter and receiver;
- - radio receiver and transmitter;
- - internet access;
- - circuit your keyboard.
Cut the wire keyboard, then make a special device that is connected to it at the site of the cut, it will be a radio transmitter.You can do it yourself in the event that you have skills in radio.Make also a radio that will be connected to the jack on your computer.
Please note that all of this will require you to programming skills of radio waves, so think about the absence of such alternative methods rework the keyboard into a wireless device.This method also has its advantages - no direct contact with the keyboard adapter, it can be installed far enough away from the radio and so on.There is also the installation of a battery compartment to power the keyboard for that use circuit model of your keyboard to find a suitable connection options.
Make your wireless keyboard using the data using an infrared receiver.It is much easier, since it is not necessary to program the wave, however, downside is that the keyboard should be located close enough to the adapter.Also, the connection should be direct.
Use the simplest way - buy a wireless keyboard, insert the adapter into your computer and disassemble the input device.Remove the transmitter and at the same time, repeat the wiring of the battery compartment.
best to use a model similar to that of your keyboard, as in this case will be less of a problem with the connection adapter and the power supply.Program here you also do not have to, and perhaps a keypad in any convenient way, depending on the radius of the signal and battery level.
often use ready-made wireless devices running on radio signals.
- how to make a glowing keyboard