Tip 1: How do I know when the house will be demolished

issue of demolition of dilapidated housing can occur for several reasons.B Did you expect your drift home to move to a new home.Or you are interested, do not demolish any house in which you are going to buy an apartment.In the latter case, when it comes to large investments and risks, check vending building better with the help of specialists rieltorskoy company.But to know the fate of their own homes not difficult.
Guide
1
Since 2005, Moscow has resumed the demolition of five-storey buildings, emergency and dilapidated housing.The list of buildings to be demolished can be found by accessing the website of a particular city or prefectural councils sites.
2
If such a list is not available, you always have the opportunity to ask a question on the official forum or post a question to the pager chapter administration.Also, find out when will (and will) demolished a house in the district can be administered by the Department of housing policy and housing - http://housing.mos.ru .
3
addition to official, reliable sources can be considered as sites of real estate agencies.Constantly updated information on homes slated for demolition X can be found, for example, at the following site http://www.realtylaw.ru/information/SnosReconstruct/Snos/ .
4
You can find out in advance, not whether you are interested in a house to house m "nesnosimyh" series."Nesnosimyh" are five-story panel apartment houses Series 1-515, block houses Series 1-510 and brick house Series 1-511 and 1-447.According to the head of the Department of urban planning policy of Moscow Sergei Levkin until the demolition of houses in Moscow is planned.
5
To learn a series of his own home , please refer to the BTI.On foreign 's house shall come to judge the appearance and searching the Internet.For example, here http://www.zdanija.ru/BuildingsGallery/p17_sectionid/34 you can see photos of houses typical series.
6
According to RIA Novosti, the demolition of five-story buildings and dilapidated housing in Moscow will last at least until 2014.And if your home still not on the list, maybe it will get there later, because lists are not more than a year.Furthermore, sinceresidents subject to resettlement in new homes in the same district, lists are checked and edited each week.

Tip 2: How to build a house in the city

Quite a lot of people engaged in the construction of houses in city .Currently very popular frame houses.They are ecologically clean.In addition, the frame house is easy to construct.
How to build a house in the city
Guide
1
Immediately it should be noted, for the spatial rigidity of the frame house need to use elements of the power frame.To make a proper transmission of the load bearing elements for walls, floors and rafters, you need to take the same step of the installation of racks wooden floor beams and rafters.Between Structures frame house can make the step from 0.5 to 1 meter.If the rack has a thickness of 50 millimeters, the step should be 0,625 meters.Such a move would force the installation of structural elements of the frame house is well-matched to the width of the mineral wool insulation boards.This is where you can perform the installation of dense slabs between the bearing elements.Also note that this installation step rafters is permissible to use any roofing material, including cement-sand tiles and ceramic tiles.
2
In order to make the basis for framing the walls, you can use the wooden beams having a section 150h150mm, 150h200mm where the second resolution will determine the width of the rack, as well as the thickness of the layer of insulation.Pre-need to make a waterproof cutoff wooden structure from the foundation.For this purpose it is best suited roofing material to be folded in 2-3 layers.To prevent lateral shift rails sill must be secured to the foundation by means of anchors.Building square squareness help reconcile the installation strapping bars.
3
install the rack frame with the best corner of the house.You can check the verticality with a plumb line or spirit level.Corner rack frame wall can be made from a bar of square section 150x150 mm or 200x200 mm.The size depends on the thickness of the insulation.Intermediate racks must be set in compliance with a single plane of the wall.Be sure to constantly check the verticality of the installation.In the future, it will avoid problems with the assembly of the outer and inner skin.
Helpful Hint
If your house is to be demolished, do not forget to find out what rights you have when moving to another shelter.
Sources:
  • department of urban planning policy of Moscow
  • know what series House

0
0