Tip 1: How to sew covers for stool

you wanted to add to your kitchen a few bright brush strokes.New covers for stools are very suitable for this purpose.This new thing you refresh the interior and if the stool hard, soften the seat.Cases with a long skirt, you can even update old but sturdy stool.
you need
  • Cover tape
  • - cloth on the cover
  • - ribbons
  • - needle and thread
  • - scissors
  • Cover with a skirt
  • - cloth on the cover
  • - Scissors
  • - sewing machine
  • Denim Case
  • - old jeans or denim
  • - colored chintz
  • - sintepon
  • - Tape
  • - sewing machine
  • - needle and thread
  • Quilted Case
  • - cloth cover
  • - sintepon
  • - underwear elastic band or rope
  • - sewing machine
Guide
1
Covers seat belts
Measure stool .Put on the size of the fabric cover.Add 20 cm on each side.Pull up the fabric by hand or on a typewriter.In every corner of the cover sew two ribbons.Case fling on a stool, and a ribbon tie the legs under the seat.
2
Cover with a skirt.Make
pattern seat.Throw it on each side of 2 cm at hem.The len
gth of the skirts make up to you, the fabric can reach the floor, completely hiding the legs of the stool, and may be short fluffy skirt.Vykroyte rectangle with sides of equal length circle skirts and stools.Just think over the top of the skirt, whether it is on the assembly or smooth.Stitch the seat and skirt on a typewriter.
3
Denim Case.Make
upper circle or a square of paper the size of stool seat .Do not forget to SEAM 1 - 2 cm. Cut the legs of old jeans.Unfold the fabric and vykroyte two identical parts Seats.Run inside sintepon two - three layers.Do frills of colored calico.Smetana, securing all the details.Sew together on a typewriter.On opposite sides of the cushions attach ribbons to tie under the seat of the stool.
4
quilted cover.
Measure out the amount of tissue in the seat of your stool .Combine with each side 30 cm. Make bend along the perimeter so as to be inserted inside the rope gum or a garment.Vykroyte piece syntepon size seats.Cloth interior of the cushion can be used either.Fold the upper part of the cover, padding polyester and lower case.Quilted on a typewriter to sintepon I did not get off to the side.Insert a rubber band or string into the prepared Bend, put the cover on a stool and tighten to cover not dumped.

Tip 2: How to sew a pillow on the stool to stool

often sewn flat, sometimes quilted pillows with strings.If the style of the room allows, you can decorate with applique or ruffles.The kitchen might look nice cushion, made of the same fabric as the mitts, pot holders and curtains.
How to sew a pillow on the stool
you need
  • - fabrics for cushions;
  • - sintepon.
Guide
1
Start with training patterns.It can be cut from a newspaper the size of the seat of the stool, which is intended for a pillow.Attach to the stool pattern and mark the places where the pillow to be attached strings.
2
Cut two pieces of fabric prepared for the pattern, adding a half a centimeter on each side as a seam allowance.For the ties cut four pieces the length of fifty or sixty centimeters wide and eight centimeters.Add seam allowances on both long sides of each strings.
3
Reduce the pattern on each side half a centimeter.According to this pattern changes cut piece of padding polyester, which will serve as a gasket.Typically used for pillows sintepon density from three hundred grams per square centimeter.If proved to be at your disposal material density from one to two hundred grams per square centimeter, cut two pieces from it.Seam at the cutting syntepon do not need to leave.
4
Fold in half the width of the straps inside out, sour cream and Stitch length and one of the narrow sides.The second narrow edge leave to be able to turn the eyeballs.
5
Remove the basting and remove the straps right side out.Fill the inside of the edge that you do not stitched, sew the fabric by hand and otutyuzhte finished parts.
6
Baste sinteponovye details to the wrong side of fabric pieces.Fold in half along the length of the strings.Baste them to the front of the lower part pillow so that the ends of the laces were sent to the center part, and they fell under the middle line.
7
Baste the fabric of the pillow right sides and Stitch, leaving twenty centimeters on either side to turn the pillow.Remove basting without touching the seams that sintepon to baste fabric.
8
Turn almost finished cushion on the front side.Fold into the allowances on the side that you do not end up scribbling and sew the fabric edge.Step back from the edge of the pillows on the four to five centimeters and route basting stitch through both layers of fabric and padding polyester.Stitch pillow on the line or sew by hand.Then you can remove the rest of basting.
Sources:
  • Making cushions for chairs and stools
  • cushion on the stool
Note
stitching sintepon, putting on a typewriter the maximum length of linesto avoid fees.
Helpful Hint
Textiles kitchen beautiful use the same colors for the manufacture of curtains and slipcovers on the stool.From the remnants of fabric can sew tack.
Sources:
  • http://club.osinka.ru/topic-37655

0
0