moldings can be described in various ways - for example, a baguette, molding or frieze.It is a decorative element that helps give the interior design perfection, aesthetic appearance.With it, you can hide irregularities, minor flaws at the junction of wall and ceiling.

to manufacture can be used different materials - a plinth can be foam, wood, plaster, polyurethane, etc. choose what it can be glued ceiling moldings, it is necessary, depending on its material.

means for attaching skirting



Most often used for bonding skirting such funds.

Adhesive polymer-based.Of these, the most common "Moment" and "Titan".They have not only a good basis for knitting, but they quickly grasped, and the elements, glued to their help, will be held securely.There are other similar solutions based adhesive po
lymers but the adhesive property is somewhat worse.

Liquid nails.Safe for almost all materials can perfectly keep the baseboard in the long term.Such compositions are neopropilenovye - they have a pungent odor and rough handling to dry can cause damage, and acrylic - safer but less effective.

putty based on acrylic.Tiles Many professionals choose it because at the putty stick skirting very convenient:
- do not need a long time to press the surface of the baseboard, and wait until he grabbed;
- the same composition can be directly cover up the gap between the wall and skirting board, if irregularities are smoothed.
Caulking will securely hold the material, it is possible to use in confined spaces without fear for their health.

The glue foam moldings



For finishing ceilings domestic premises often choose a plinth made of polystyrene foam.This material and practical, and inexpensive, and do not look worse than plaster or wood.You can simulate the columned hall, and it does not get too expensive.The most effective and safer to stick skirting foam using an acrylic filler.

Liquid nails and other adhesive mixtures can also be used, but only if the composition allows it.The packaging must contain indications. application of adhesives containing corrosive substances may end the fact that the plinth is melted and spoiled.

adhesive for ceiling moldings can be made independently.It will take not so many components: finishing plaster, PVA glue, water.The container is filled with a sufficient amount of filler, it is added to PVA in a ratio of 4: 1.Water is added, the solution was stirred until a creamy consistency.After this you should give it to stand for about 10 minutes and stir again.Use thus prepared solution may be a half to two hours.