- - ledge;
- - curtains;
- - tapes;
- - sewing machine;
- - thread.
Before you start doing loops defined with height and treat upper curtains.Note that the width of the mounting tape have to close from the inside hem fabric.If the eaves are open and you are using a narrow braid, then to the desired amount of tissue for the treatment add 3 cm. This is done to ensure that the loop does not peeping over the curtain.
Loops can be attached to the curtain
by means of Velcro or buttons Seat, sometimes performing the role of the loop ring that is attached to the curtain clamps or magnetic rings.Effectively look curtains tied with a bow to the rod.
Samu loop can be made of strips of fabric, lace or a strong thick thread.To do this, you need to determine the number of loops to measure the distance between the hinge and mark with chalk or pencil these places.Loops can be long, can be short, it depends on the cornice, the type of curtains and interior.However, they should be identical.Before you cut into strips of cloth, be sure to measure out and then prostrochite each loop along.Loops sewn by hand - a long and troublesome task, so use a sewing machine.Remember that the loop should be strong.In addition, you can buy in the store ready webbing with loops and just sew it to the curtains.
hinges need to sew on the mounting braid before it is connected with the curtain.Bands can shrink, so it is better to pre-ironed with steam.
Webbing loops ready to put down, superimposed on top of the front side of the upper allowance, align the edges.Stitch is necessary so that a line drawn from the wrong side of the fabric, captures the braid.Therefore it is necessary to withstand indentation from the top of the fabric at the same level throughout the line.In that case, if the fabric is transparent, it is done with ease.When working with an opaque cloth, use a guide line, built into a sewing machine or a magnetic limiter.
Once the line is ready, make a tie-off and cut the webbing with an allowance of 2 cm. Then tuck allowance, wrap the braid on the wrong side of the curtains on the lower part of the fold.For further actions iron the iron crook.Ready line should not look through the front of the curtain, as it remained under the braid.
curtains flip face, braid must be below taken with the second marking, anchoring, line.Then turn on the wrong side of the curtain, spread the entire length of the iron and iron seam allowance over the entire width curtains.After that you can hang the curtains on the ledge.
hinges have a greater weight load, so they need to sew accurately.Furthermore, the mounting tape is sewn to the curtain at least two lines.One line on the bottom of the braid, the second top.
much more comfortable attachment to the hook, they are easier to sew.Curtain hook quickly removed from the eaves and hung up without too much difficulty.