you need
  • - Plastered;
  • - spatulas;
  • - Skin;
  • - Ground;
  • - Utensils of putty;
  • - Roller.
Guide
1
Take warm water and a foam roller, wet it and slide it from the bottom up on the old wallpaper that they are thoroughly moistened.Do not wet the area too much.The walls are easy to absorb water and dries quickly, and you'll do extra work.Once the wallpaper get wet, remove them with a spatula.Pick up from the bottom of the sheet and pull up, the wallpaper will be removed easily.If the wallpaper is not sufficiently wet, then wet them again.And so long as the wall will not be free from the wallpaper.
2
To proceed to the next stage of work, prime the walls with primer deep penetration and let them dry.After this procedure, co
nsider the wall, they may need to be repaired.If you find such a place, then repaint them or plaster mixture, or basic filler, allow to dry and then sand the sandpaper.Then clean the wall of dust, prime with and allow to dry.
3
Wall shpaklyuyut 2 or 3 times, depending on the chosen wallpaper.Take a basic plaster and spread it as it is written on the package.Putty start from the top wall, descending gradually down.To work it was more convenient, take a ladder or table.But be careful not to make any sudden movements, and remember that you are on top.
4
Take a spatula 15 cm wide, inset dishes of putty trowel and pass on a wider (35 cm).Put the filler with a spatula to the wall and spread to the surface from left to right so that the entire coat lay on the wall.Excess putty to remove this section, leading trowel from right to left.Next put a layer so that it overlaps the first centimeters 5. Do not try to do too wide arm span, trying to capture a large area of ​​the wall.Movement should be clear and confident.
5
most uncomfortable area for putty - a bottom wall.Pick up the plaster of dishes and pass it on to a large spatula.Sit on his heels, and set a spatula to the wall near the floor.Now the movement of the hand from the bottom up putty smear on the wall.Remove the excess with the same motion.Try not to make passes on the wall.If you think that the filler is not enough, put more - it does not hurt spackling.
6
Once you have plastered walls, let them dry.Then sand the clean the dust and prime.Once the walls are dry, proceed to the second spackling.The second layer is made finishing putty.It is finer in structure than the base and fills the smallest irregularities of the wall.Spackling is made the same as the first layer.From left to right, apply the putty, and from right to left - shooting.
7
If you choose wallpaper subtle, such as silk screen printing or vinyl, that shpaklyuyte wall a third time.These wallpapers require a more thorough preparation of the surface.The third layer also serves as the finishing putty.After it dries carefully sand the wall.Then clean them from dust and prime primer deep penetration.
8
If you choose wallpaper with a thick substrate or structural, the shpaklyuyte wall twice: once the base for the second time finish.And be sure to trim at the end of their prime the walls of putty.This is an important element in the final stage of finishing work before pasting wallpaper.