- water, rags
- Emery number 1000
- acetone or Cleaner for plastic
- primer and paint for plastic
- Lac (if necessary)
- abrasive paste and sander
- gas burneror hair dryer building
Prepare damaged plastic to paint.If the surface is a large part of the product at its ability to separate and rinse thoroughly on both sides.
Remove with sandpaper all vspuchilis paint and check your finger left if small grooves or roughness.To work it is recommended to use sandpaper number 1000 and better stock up with two or three sheets.
Strip sanded surface using acetone or a special c
leaner for plastic, soaking in a chemical means a clean soft cloth (lint-free).It removes dirt left by sand paper and plastic.
Buy a bottle of special primers for plastics in the form of a spray, if the damage has penetrated to the old ground.Carefully read the instructions in the cans.Typically, it was shaken for 7-10 minutes, and sprinkle a little in the direction of the means to protect the plastic from the possible lumps.
Apply primer on the scratched plastic with a distance of 20 cm, moving parallel to the surface of the part.The damage should be covered first by a thicker layer of primer and then - more subtle.If you want to do a third, the lightest layer.Allow the primed surfaces to dry completely.
Scuff another plastic surface, and then wipe it any cleaner.Proceed for painting plastic.The dye in the container also needs to buy specially designed for this type of plastic products.Hue selected carefully so as not to have the slightest discrepancy with the color of the damaged coating.
Spray paint on a single layer of plastic at first, and then (after drying dye 10-20 minutes) - the second.If deep scratches may need multilayered decorative coatings.If there are ugly streaks of paint, just wipe them with a wet cloth.While the painted item dry, protect it from dust - otherwise it will stick to the decorative layer.
Put colored coating on the hour.If the plastic part varnishing, apply varnish on top of several layers, trying to fill their surface.
Some craftsmen clean scratches from plastic gas burner or a building dryer plastic welding.Pre-sanding the damaged area, carefully traversed these devices on a scratch - under high temperature, it sticks together and becomes unobtrusive.It is best to try this method first on a piece of plastic of the same type.When cooked plastic surface must be absolutely clean, otherwise under the influence of the torch or hot air gun it quickly darkened.
small scratches, which damaged only the top layer of paint can be polished abrasive paste.Proceed sander packed with foam.These materials are available at the auto shop.
- How to remove scratches
- how to remove scratches from plastic