you need
  • - plastic panels;
  • - rake;
  • - the profile of the corner / starting / finishing;
  • - ceiling moldings;
  • - hangers;
  • - tool.
Guide
1
Measure your toilet.You'll need the following dimensions: height, length, width.When measuring consider all available projections, the areas around the doors.To close the communication, calculate the optimal size box.
2
Calculate the amount of materials that you will need to finish the toilet.In commercially available plastic panel width of 0.25 m and 0.375 m. If the walls of your toilet is not enough flat, buy dry rail measuring 10 × 50 mm for rack mounting.Do not forget to buy the starting and fini
shing profile, internal and external corners, ceiling moldings and corners him.All this is to buy a small margin.
3
Treat rail one of the trains that protect the wood from mold and mildew.After the rail is dry, begin to assemble the frame.Rail sawed into segments corresponding to the horizontal size of the wall.On each wall fasten four slats.Racks are mounted parallel to the floor and with each other, with a distance of 0.5 m between them.For installation, use the dowel-nails.
4
Decide where you prefer to start the frame sheathing panels.Trim the start or angular profile (depends on the location) to the desired size.Secure it to the frame using a stapler or small screws.Use level - the correct installation starting element, much depends.Cut the panel to size and insert it all the way into the starting profile.Staplers secure the panel on the rails.Subsequent panels are mounted in the same manner.
5
produce cutting panels before installation, pre-measure the height again.No significant differences are excluded.Holes plumbing and ventilation hatch cut out with a sharp knife.
6
Engage in installing the ceiling.His installation differs only way of fastening the frame.The frame of the light bars of small cross-section or ceiling profile is mounted on the straight suspension.This allows you to adjust the height of the ceiling for the purpose of accommodating the lamps.Holes are cut with a knife as well.Along the edges of the ceiling leave small gaps, they will insert ceiling moldings effortlessly.
7
Use frameless way to the toilet skin panels, if you are the proud owner of a toilet with smooth walls.In this case the panels are attached directly to the wall.Choose the most suitable for you: mounting glue "liquid nails" for panels or dowel-nails.In all other actions similar to those described above.