- - spatula;
- - Brush;
- - water;
- - sander;
- - respirator;
- - Points;
- - Brush;
- - roll;
- - gun.
If you need to paint the walls and ceiling with latex paint on a layer of lime normal, then it can be done immediately if lime is not deposited a thick layer and disappears.Vodoemulsionku with any color scheme falls on the fine is generally known and does not require pre-treatment.
If there is a thick layer of lime scrape the entire layer with a spatula, zashpatlyuyte walls, and only then proceed with staining.
If you plan to paint the white-washed walls with enamel, you would have to completely remove the entire layer of lime, as with time, all the enamel begins to peel off, together with the former whitewash.
To remove a thick layer of
lime, use a spatula.A thin layer is sufficient to wet and rinse off with a brush.If you have a grinder, for the final alignment of the walls, use it with sandpaper № 0. Do not forget to wear a dust mask when sanding, glasses, open all windows and doors, as the dust from lime is very poisonous.
Before painting prime the walls with wallpaper glue, varnish or dilute the paint that you apply in a ratio of 1: 5 and apply two coats on the unpainted surface.After 24 hours, commencing immediately staining.
main enamel layer is applied with a brush, roller or spray gun.If you use a roller or brush, it is enough to paint the surface into two layers.After the first time, give coloring paint to dry completely for 24 hours, then apply a second coat.
If you use airbrush need triple application of paint as a coat of paint goes thinner and double staining is not always effective and does not give a smooth coating layer.
When using the gun as you would with a brush or roller, every layer must dry completely, and then you can apply the next layer.
- than can be painted whitewash