you need
  • - foam and gun;
  • - pieces of wood, foam, plastic, bricks;
  • - bottle with water;
  • - konopatka;
  • - moss, hemp or jute felt;
  • - knife;
  • - a hammer;
  • - putty;
  • - skirting or decorative tire;
  • - fasteners or glue.
Guide
1
If the gap between floor and wall too much (from 1 to 8 cm) of it pulls cold and damp, to decorative trim cover it with foam or caulk.Wide slit prefilled what some inexpensive materials to reduce the consumption of foam, such as wood, foam, plastic, brick.
2
Note that gap foaming can be carried out at temperatures above + 5 ° C.Before working with assembly foam wear gloves, because with it, it almost does not wash.Shake the bottle, shake it for at least a minute.
3
Treat all surface water -
it is possible to use spray or bryzgalku from a plastic bottle (punch some holes in the lid with a nail).
4
Remove the cap screw up, turn the bottle upside down with the foam and click on special assignments.Zapenivayte the gap by one-third of the gap, as the foam will increase 2-3 times.After the gap is closed, sbyznite with water.If within half an hour left gap , walk with the balloon again.
5
After 8-10 hours, the foam is dry, remove the excess with a knife.
6
If you decide to close up the gap between wall and floor using caulking, take moss, hemp or jute felt.Note that the felt need to pre-soak in formalin to not start mol and moss should not crumble in your hands.In addition, you will need konopatka (spatula made of wood or metal).
7
Roll material in the sausage, put to slot and gently hammer konopatki so that it fits inside the village.To work more effectively with a hammer.
8
to seal a narrow slit (less than 1 cm) can be used putty.Apply it with a spatula and gently smoothed, to ensure tightness.
9
Once embedded slot, get decorated.Depending on the interior of your room, choose a decorative tire, plastic or wooden plinths.If you are not much concerned about the appearance of corners tighten tires with screws, otherwise acquire special profiles, which consist of two parts.In this screw to the floor of the lower and upper simply insert into the slots and snap.Plastic skirting well enough to put on a strong glue.