The first step is to clean the entire length of the pipe since its release on the roof.In order to clean the pipe, close to the valve house, which regulates the output of the tube.
Prepare a thick long chain or a stick.In extreme cases, suitable cable with tightly hitched load.Climb up to the roof.Start drive on the inner edges of the pipe fro
m side to side.This should be done for a long time, as mentioned above, the carbon black has a very oily texture, and it is difficult to scrape off the first time.Clearing the tube can go down from the roof down.Now turn to clean the chimney at the very oven.
furnace valve repeatedly pull and push.This will help the fallen soot from top to go down to the lower chimneys .From inside the firebox also need to clean the base of the pipe and wells.
Then pick the kiln wells.Every owner knows where his stove they are.Usually they cost door.Depending on the stove can be 2, 3, 4, 5 or 6 wells.On opening the wells Scoop of them black.At the top of the wells to be cleaned with a brush.Close the wells.Dilute pure clay.Seal the gap formed.Allow to dry.Dissolve the clay mixed with sand.Powertrowel the cracks.All whiten with lime or latex paint.Only with such a well-cleaning oven will burn and will not smoke.This procedure makes the firebox safe.
Tip 2: How to clean the chimney
If you bought a house with a fireplace or stove, or simply decided to spend spring cleaning, you will not an easy task - cleaning the chimney .The difficulty lies in the specific cleaning Russian pipes which usually are narrow and uncomfortable.Therefore, to qualitatively carry out the cleaning inside the tube, you should perform the following series of actions.
Start cleaning from the top.Start this operation from the fireplace or stove is almost useless, since the end of the harvest will again be all dirty.So lock the lower output or close the chimney himself fireplace.If there is no door, get some inserts that could be used as a plug.This is a prerequisite, since dumps from above fragments of soot are so large that they create huge clouds of dirt that can bring all the blackness of space.
Buy store in the building a special brush to clean the pipes.Do not use a rag to mop wound, how often did before and do now.You will not be gathered rags and quality will not be able to remove the soot from the chimney.It is much easier and more economical to buy later a cleaning kit from their brush and replaceable brushes.
Use conventional detergents or buy specialized to deal with soot.In any case, it is to start with the pipe, gradually falling below along it.Do clean sweep at 10-15 centimeters, changing every 10-15 seconds away, which made cleaning.After one such compartment thoroughly cleaned, be sure to wash your brush before the next.If you make a dry cleaning then simply scrape off layers of soot and accrued to the extent necessary, clean the brush.
least Wear safety goggles when cleaning the bottom of the second chimney .Best of all you should have a full mask, as this procedure is really dangerous.After you pass all the walls completely, is once again walk along the pipes, flush the remnants of the cleaning agent.
- unclog pipes