Guide
1
wall can be insulated penofolom both outside and inside.When setting is best used perforated penofol.In addition to heat and sound insulation makes it the protection of the building from rain.Also, to ensure the withdrawal takes place a couple of designs.
2
Warming often produced inside the building, as is an increase in economic efficiency.It will also decrease the heat intertsii structure and there will be no chance of condensation.
3
for thermal insulation of walls, by regulatory requirements applicable penofol A-type.It is one-sided and has a thickness of 4 millimeters.It is mounted with solid insulation, for example, mineral wool or foam.The thickness of the solid insulation can be
calculated as the thickness of the walls.Sometimes, if the material is low thermal conductivity, for example, hollow brick, it can be made an exception solid insulation.So often do the repair of apartments.If you miss a cold wall, it is sufficient to apply only penofol.Also for light construction, which will be operated only at zero temperature, you can not use massive insulation.You only need to install penofol.
4
for thermal insulation of walls, by regulatory requirements applicable penofol A-type.It is one-sided and has a thickness of 4 millimeters.It is mounted with solid insulation, for example, mineral wool or foam.The thickness of the solid insulation can be calculated as the thickness of the walls.Sometimes, if the material is low thermal conductivity, for example, hollow brick, it can be made an exception solid insulation.So often do the repair of apartments.If you miss a cold wall, it is sufficient to apply only penofol.Also for light construction, which will be operated only at zero temperature, you can not use massive insulation.You only need to install penofol.
5
If the device is made of insulation of the attic, the penofol must be laid directly on the rafters.Material should be placed parallel to the eaves.It is necessary to pay special attention to-lap.It should be more than 10 centimeters.Fixing material carries with staples.Sag should be no more than 2 centimeters.This provides free condensate from the sheathing and rafters and prevents interference.When there is a decrease in temperature in the attic ceiling, and the water vapor condenses as droplets flow down.Insulation at this time and there is the appearance of moistened wet stains on the ceiling.That is why penofol layer must be installed under the heater.