- - oven;
- - level;
- - Bulgarian;
- - trowel;
- - spatula;
- - brick;
- - tiles;
- - cement.
If your stove (aesthetically) are satisfied, then the pre-construction figure out all the functional issues.So, you should know that can not be used as fuel coal and its derivatives.Melt a fireplace only dry wood or wood briquettes.If the area where the house is located, problems with materials for kindling in the future will not arise, feel free to proceed with the construction of the furnace chimney.
Get a necessary tools.First of all you need a level Bulgarian, trowel, trowel.With re
gard to the purchase of materials, it all depends on your individual drawing.Make it, and then calculate how many bricks, tiles, cement, etc. You need.
If the foundation and the furnace body made qualitatively, it makes no sense to disassemble the entire oven and start the construction of "from scratch".Between the foundation and the floor of the furnace should be a distance of about 25 cm filled with sand, and the depth of the firebox should be about 50 cm. The body should be laid out inside with refractory material.If these conditions are met, proceed to the chimney.It may have much to rebuild.The height of the chimney pipe to be 7 m, and its inner area be not less than brick (about 13 * 25 cm).Must also be designed specific channels to be within the direct air flow along the door to black is not settled on the glass.
If the furnace for burning a small hole, expand it and close the door a decorative fireplace.It must be made of refractory glass.What happens next steps will be connected has only decoration stoves.
Tip 2: How to build a fireplace oven bath
great popularity currently enjoyed stoves and fireplaces .You can build them yourself.For this work will require high-quality materials and tools.It is desirable to have at least minimal knowledge in the field of construction.
Construction of stoves and fireplaces should start with the foundation.It is recommended to pour the foundation of the belt type.Remember, the foundation of the fireplace should not be linked to the foundation of the building.It must be indented more than 25 centimeters, which is then filled with sand.Fundam poured into predetermined formwork.After the work associated with the construction of the foundation is finished, you can proceed to the creation of isolation.It is necessary to prevent the ingress of moisture in the finished stove or fireplace.Next, the masonry brick.
furnace and fireplace consists of several parts: the body, the sweeping, flue, foundation.Pay special attention to the depth of the firebox.It is recommended to make it equal to 50 cm. The firebox will not lose heat and the smoke will not get into the room.Proper location of the firebox will easily comply with the direction of the smoke in the smoke box.Then you need to install over the firebox and ash pan Koloskov bars.
walls and base of the housing is recommended to decorate the inside with refractory material.At a distance of 50 centimeters from the fire floor are finished with non-combustible materials.
Pay attention to the slope of the rear wall of the furnace body, and the fireplace.Small slope should be at the upper portion of the rear wall.Thereby significantly increasing the heat transfer.
flue must break down pyramid.This is the final part of the masonry shell.At the top of dymosbonika do smoke damper, which will create an obstacle penetration of cold air into the room when the fireplace is not in use.Once the connection is done with the sweeping flue, the most important part of the work is over.
If masonry is made even and level, then no problems will arise.After the erection for some time, do not use the oven th and fireplace.After a month, you can plant them in the fire.