- washing machine, new bearings, tools, bar, training for assembly and disassembly of the washing machine.
Before proceeding to replace bearings washing machine , you must disconnect the machine from the electricity supply, water supply and sanitation.
Then, you need to merge all the available water in the washing machine through an emergency drain, and use a screwdriver to remove the top cover from the rear wall of the body of the machine.This will give access to the drum bearings.
Further, by removing the belt from the pulley of the drum, it is necessary to lock the pulley itself.To do this, you can use any block of wood.
Then, unscrew the screw and remove the pulley drum.Perform this procedure should be very careful not to damage
To be able to remove the clamp and the lid of the tank, remove the spacer bar and the counterweight.
TEN freeing all existing wires, you can start unscrewing fastening assembly bearings .After that, by removing the grounding bar, you need to loosen the screw to remove the clamp.However, collar, the seal is removed and the lid of the tank washing mashiny.Pri doing this disassembly, it is important to monitor the integrity of the wires.
To gain access to the bearings, remove the pot washing machine.
removing the oil seal using a hammer, start to beat out the bearing.In place of the old bearing, it is necessary to establish a new, exactly the same.It is important to follow when installing the bearing to it that he went straight.
After replacement made, you need to collect the washing machine in reverse order.Thus it is necessary to make sure that all the details were correct and in place.
Bearing Replacement in the washing machine - it is a very time-consuming process for which you have not enough strength, patience and investment.Therefore, if the change will be made by yourself, you need to prepare well for this procedure.
- how to change the bearing Indesit