- cruciate screwdriver, pliers.
Disconnect the washing machine and turn off the water.
cruciate Take a screwdriver and remove the two screws that secure.These screws are located on the rear wall of the washing machine and secure the top panel to the case.
Raise one hand the back of the machine cover and slide the cover towards the back wall.
Remove the washing machine , when you feel that it is disengaged.
Remove the screws fastening located on the rear cover of the washing machine , and remove the back cover.
Slightly tilt the washing machine back to get free access to the bo
Clear, with a pair of pliers, a spring supporting unit laundry.
Remove the old belt , turning it on a pulley.
Loosen the motor and slide it in the direction of increasing the length of the belt.
Tighten.Put belt , first, on the motor pulley and only after that - on a drum.If the design of your car does not include belt drive, it is necessary to replace it with a new one.
Take the new belt drive .It is important that the new belt fully consistent with the model of your washing machine .To verify this, read the markings of the old belt.The first four digits indicate the marking of the strap length.Followed by the letter refers to the shape of the tracks.The last digit of the marking indicates the number of entries.All symbols marking the old and the new belt should match.
Tie to a new strap small solid thread.
Skip belt over the top.Put belt on the engine with one hand.The second hand, while, should pull the belt thread tied up for not letting him slip off the pulley.
Put the washing machine to its original position.
Hook the edge of the belt pulley for the drum.Very gently, but firmly, turning the drum clockwise Push all belt .
Check the quality of their work.Turn the drum.The absence of distortions and background noise while rotating the drum shows the correct installation of the belt.
Collect washing machine.
When the drive belt failure could damage the sensors, electrical wires and other elements located in the back of the washing machine.During replacement of the belt is desirable to diagnose and, if necessary, to eliminate these faults.
- how to replace the belt from the washing machine