Tip 1: How to fix a leak in the toilet

When the plumbing in the house is working correctly, it nobody pays attention.But as soon as the murmur is heard from the toilet or dripping water, we have cause for concern.Leakage can cause us a lot of trouble, both household and financial.After all, very few people want to talk with the neighbors about the flood.Paying attention to the sanitary equipment periodically, you will save yourself a lot of problems.
you need
  • Sandpaper, knife, oakum
Guide
1
If you find flow of water in the toilet , try to determine the cause of the fault.Carefully remove the cover of the toilet tank, careful not to damage it as to choose a new cover will not be easy.The most common cause is a leak gapping "pear" to the saddle.This can occur by deformation of the walls of the "pear".Worn "pear" should be replaced.
2
If the new "pear" is not at hand, sometimes temporarily, you can use the old, tightly stuffed it with suitable material (hemp, burlap, twine).This will give a "pear" spherical shape.
3
If the walls of "pear" is not deformed, but it still does not close the drain, weighted it with a big nut that must be spread on traction.
4
If the water leaks caused by corrosion of the saddle, the appearance of it sinks or build-up, remove the "pear" and using sandpaper to remove the rust from the surface of the saddle.A thick layer of rust can be scraped off with a knife.
5
If the water in the toilet is constantly flowing, while not filling the tank, it may be due to misalignment of the float.In this case, the float is at the bottom of the toilet tank.To resolve this problem stir gently float in different directions.In most cases, normal operation is restored toilet.
6
if committed with a float operation does not help, and the water continues to flow into the toilet bowl, probably need to correct the shut-off valve (it can be skewed).Special tools are not required for that, we just have to carefully remove the toilet tank cover and correct the hand valve or the float.
7
With operations in the cistern observe accuracy.It is important not to break off valve.A worn valve may break off and issue a jet of water under pressure.Therefore, before the repair work shut off the water supply to the cistern.

Tip 2: How to fix leaking toilet

to live in an apartment with the comfort, it is necessary to closely monitor that all communications were operable.It is unlikely that someone like that in the night are lower and neighbors angry voices shout their fill.So it can happen, for example, if all of a sudden the toilet was leaking.Before you take any measures to solve the problem, we must find out the cause of its occurrence.
How to eliminate leaking toilet
you need
  • - Clippers metal;
  • - sealant;
  • - drain valve (possible).
Guide
1
Check hose filling.When violations of the filler hose is a sharp decline in water pressure, which is fed into the tank.The drain valve at the same time can not fully close the opening of a tank, and the toilet constantly running water.To resolve this failure, remove the tank lid and consider filling hose, which is connected to the intake valve.Make sure that the filling hose is located at the correct level relative to the overflow pipe.Over its highest point of the hose should not be higher than three centimeters.After checking and fixing the position of the inlet valve is necessary to reproduce the cycle of filling and draining the tank - to evaluate the results.
2
Check the setting of the float.With the float controlled level of water supplied into the tank.If the float poorly regulated, for example, is too low, water will be too low for normal drainage.Too high the float leads to disruption of the intake valve.On overflow pipe as a guide for adjusting the float applied mark.You can use it in order to bring the float.It is necessary to trace the entire process of filling the tank.If it is filled to a level that would be above or below the level of the float have to adjust - it can be done manually, fixing the float slightly above or below a specified level.
3
Try to adjust the lever drain hole.Too short or tangled chain prevents the valve from closing completely drain - leakage is constant.If the chain droops, the drain valve can not be opened until the end of the descent of water, and the pressure is low.Chain position must be such that it droops, but barely.
4
Change the drain valve.Most often leak toilet is because the water is continuously flowing from the tank into the bowl.This happens due to improperly arranged a drain valve.If you fix it, you can restore the normal operation of a tank.But best to make sure that other causes of leaks are excluded.If all of the above points are not the cause of the leak, the case could only be in the drain valve.Its walls are in continuous operation can be deformed, which does not keep the water in the tank scored.As a result, there is a continuous flow of water, and the valve is correct meaningless - you can only replace it.
Note
Upon detection of a leak on the floor under the toilet may not be immediately clear for what reason it occurred.To eliminate breakage, it is necessary to determine its cause.Most of these problems can be solved easily by hand.
Helpful Hint
When gapping toilet gaskets can also leak.Simple treatment of all joint sealant can help resolve the issue.
Sources:
  • How to fix a leak from the toilet cistern
  • how to fix a leak from the tank

0
0