you need
  • - pipe for internal insulation (smaller diameter than the base);
  • - basalt wool;
  • - binding wire;
  • - stainless steel sheet;
  • - rope;
  • - handle of a shovel;
  • - screws;
  • - clay-sand mortar.
Guide
1
To begin isolating chimney, take basalt wool, and with the help of her wrap tube in several layers.Then fix what happened, the binding wire.Oshtukaturte clay-sand mortar.
2
Measure the perimeter of the pipe with a basalt wool.Based on the resulting calculation, cut stainless steel sheet required length.The width of the steel sheet should be at least one meter.
3
To make the correct form of the metal blank, wrap it around the chimney smaller.The corners are rounded by hand or by using rolls.
4
The resulting blank put on the stove pipe .If the width of the workpiece is more than half a meter, use two ropes.Begin to pull the rope in the circumference of the pipe, throwing both ends of the rope on the handle of a shovel.Continue to twist the stalk.
5
hands gently tamp stainless steel sides to metal is not cracked.To complete the process, to tighten up the stalk to the desired tension.
6
As soon achieve the desired tension, align and secure the metal structure by means of screws.
7
to continue insulation chimney repeat the procedure a number of times.Each time the rope slide in the right direction, subject to the following sheet of stainless steel with a tie-in and the lower edge of the sheet fasten only one screw.