Tip 1: How to apply facade paint

facade of any building is constantly exposed to precipitation, rain, snow, and can withstand high and low temperatures, UV radiation, so the paint that is applied to the outer side of it, should be as stable.Paints and varnishes market offers a stable facade for the exterior.The methods of their application depends on the brand of paint.
you need
  • - Brush;
  • - roll;
  • - gun;
  • - solvent;
  • - white spirit;
  • - spatula;
  • - linseed oil;
  • - primer.
Guide
1
Before applying any paint, prepare the surface.If the facade has been painted before, remove all old paint using a sander or chemical removers.If necessary, align the surface, apply a sealer.Give it time to dry.Cover the entire surface of the facade of the varnish or primer.
2
If you are going to put on the outer part of the facade of the aqueous dispersion paint , which is based polymeric binders, preservatives, plasticizers, as well as thickeners and corrosion inhibitors, apply it with a large brush or roller.The ink has a dense struct
ure, so it applied by spray gun impossible.Any water-dispersion paint can be applied to dry or damp surface to reduce the flow of paint.
3
enamel facade presented to trade in a wide range, oil, alkyd, epoxy, polyacrylate, silicone.Any enamel can be applied with a spray gun.If the paint is very thick, dilute it to the desired consistency with a solvent or mineral spirits.
4
Oil paint is applied on the wooden facades.Paint can come in two forms - in a ready-to-eat and dough-like paste.With the help of paste inks, you can carry out restoration work.Seal with a spatula all the bumps on the surface, and then dilute the paint solvent 646 to the desired thickness and apply with a brush, roller or spray gun on the facade.
5
silicate paint is applied to a low-fat, completely cleaned from old paint surface.These types of paint can be applied to only the facade in a warm dry weather.After drying, the facade is protected from exposure to precipitation and UV radiation.
6
Silicone facade paint is applied to the surface with a brush or roller, as the paint is sufficiently viscous composition that protects the surface for a few years.All silicone paints are made of resin, forming a film without surface tension so applied to the filler or plastered surface.

Tip 2: How to Apply facade paint

Modern facade give plastered and concrete surfaces an attractive appearance which is maintained for many years.And along with the decorative qualities, this material provides protection from the outside grounds of destructive weather.
How to Apply facade paint
you need
  • - exterior paint;
  • - primer;
  • - a wooden bar;
  • - paint roller;
  • - Brush;
  • - putty;
  • - spatula;
  • - chalky talker.
Guide
1
If the surface that needs painting, paint already have, make sure it is not cracked, and the new coat of paint does not dissolve an existing one, and starts to crumble.To do this, apply a small amount of new paint on the old one.If within 30-40 minutes, nothing will change, you can start painting.Otherwise, the old coating will need to be removed completely.
2
new or refined base check on the readiness for painting, spending it on a piece of wood.The surface is ready, if there were traces of wood shavings.Zashpatlyuyte all cracked, chipped and holes in the plaster.After drying the solution, clean the surface with a brush.
3
Challenge base on absorbency.To do this, share it with a damp sponge.If the water is absorbed by the active wall, prime the surface.For treatment of highly porous and fragile facade surface using a primer of deep penetration.For a surface with fine irregularities and minor defects choose filled primer, filling and stabilizing the surface layer.
4
Those portions of the facade, which do not need to be painted, for example, lined with tiles, cover the chalk mash.This will facilitate the removal of random spray paint.
5
facade Divide into equal portions of labor input.Their boundaries often defined along the lines of ledges and pilasters, and on the smooth facades - fixing downpipes lines.Staining pass roll on a flat surface up and down or back and forth.Bands of paint must be superimposed on one another at 4-5 mm.To paint the interior angles, use a brush.
6
painting the walls in a single layer, first apply the paint horizontally.Covering so the first section dedicated entirely, blend the paint vertically.Painting the facade in two layers, the first layer is applied horizontally, second - vertically.When painting three-layer first and third apply vertical and the second layer - horizontal.
7
After painting the first section does not wait for drying the edges, and immediately proceed to the next coloring.This will improve the coverage of material and avoid the appearance of seams.
Note
Do not paint the facade in hot weather under the influence of sunlight on the surface, as well as in rain and strong winds.

0
0