Guide
1
Shut off the cold water and empty the drain flank.Flexibles unscrew from the tank, as well as from the water supply, because in its place will rise a new one.And in the case of the metal liner need to cut it out of the tube, and then by the aqueduct to disassemble the first fitting, in order to be able to wind down nut flexibles.
2
next step is the dismantling of fixing the toilet to the floor.If fixing is carried out by means of bolts - unscrew them by cement - the ability to break it for either the toilet in the places of its fastening to the floor.Once you remove the lock, tilt the bowl back to the stop, so that the water remaining in the cavities of the toilet,
merged to the end.
3
Then disconnect the bell.If it is corrugated, simply remove it.But to detach the plastic or cast iron bell is necessary to remove the toilet.Flare versed as possible before the first connection.This is necessary to insert a drain flutes.You can also cut a bell the size.
4
Set sewer drain socket corrugation.For this purpose it is necessary to lubricate the sealant from its entry into drains.Pre-clean the grease and sewer socket itself.Now insert the corrugation to the stop.To the smell of sewage in the toilet did not spread, cover with a cloth open entrance flutes.
5
So dismantled the toilet.When installing a new toilet consider two cases.In the first case the floor is flat, because the old toilet was attached to the floor by bolts.If the new toilet fixture like, try to install it on the old place.Drill holes in the floor of the plastic plugs and replace them with new ones.If the old holes gain wider than the new plugs, toilet will be unreliable.You will have to drill new holes.Place the assembled new toilet to the place where you are going to install it, and then mark the floor space for new openings, given the size of the bowl, and the length of the corrugated liner.Drill holes, insert the dowels and fix the toilet in place.
6
If the toilet was cemented in the floor will deepen.Clean the recess of the cement.The typical houses of cement is usually a wooden mortgage.Basically, you will be able to align the floor with the help of a thick solution on top of the toilet set and fastening with screws to fasten it to the wooden mortgage right through wet cement screed.After drying cement you will tighten up the screws.However, there is one caveat: a mortgage can rot over time, so check it on the strength of such a method should not be.It is better to tie, especially if there is a mortgage in principle.Screed can dry from day to three days, depending on its constituents.After this time, it can easily hold dowels.
7
Carefully drive in dowel fixing in ready-made holes in the floor.They must either go hard or easy.Stability toilet depends on this step.