you need
  • - Grease "Litol - 24";
  • - set of wrenches;
  • - gland;
  • - Phillips screwdriver;
  • - car trehlapy puller;
  • - scalpel.
Guide
1
Construction of the bearing assembly of different models of washing machines are very different.For lubrication SM «Indesit» Remove the rear and the top cover.Remove the drive belt from the pulley drum.Hold the drum pulley arm wrench, unscrew the locking screw screwed along the axis of the drum.Unscrew the spacer bar to the rear of the washing machine casing.Automobile pulley puller, carefully remove the drum with its axis.Disconnect the wires on the chassis of t
he tank heating element and temperature sensor.
2
Remove the screws fastening the upper transverse bar.Move it along with springs to the front of the washing machine and secure.Unscrew and remove the screws that secure the counterweight.
3
Unscrew the bolts from the bearing flange of the tank cars.Unscrewing the screw clamp ring, loosen the clamp and remove it from the tank.Remove the lid of the tank.Automobile puller remove the flange bearings from the shaft of the drum.Having hooked a screw-driver, remove the seal from the flange bearings.Often through the weakened gland in bearings gets water, which leads to their rapid corrosion and failure.
4
Gently pry off with a scalpel and remove the protective covers from the bearing.Lubricate the bearings grease "Litol - 24".Reinstall the covers of bearings.Grease lubrication new oil seal.Set it in place.Grease lubricated shaft of the drum.Fit the flange on it with bearings.
5
Before installation flange on the tank cover note the gasket between the flange and the tank cover.If the gasket is damaged, apply before installing the flange gasket on both sides of sanitary silicone.Then screw the flange bolts to the top of the tank.Note: If you used silicone, and thoroughly clean the flange and the tank cover with a dry cloth.In joined surfaces must be water, or silicone is adhered and at this point the tank may be leaking.
6
further assembly of the washing machine carry out the reverse order of its disassembly.