- - vegetable oil;
- - cotton cloth or cotton wool;
- - sponge;
- - soap;
- - hot water;
- - brush, sponge, pumice or sandpaper;
- - cleaner for foam and aerosol cleaners, wipes;
- - nourishing cream or visceral fat.
drench uncured assembly foam on hand cotton cloth or a cotton swab dipped in any vegetable oil.Rub the skin stained for 7-10 minutes.
Poparte dirty hands in a hot bath and try to scrub the skin with mounting foam rigid foam sponge side and a saturated solution of soap.
If contamination had to congeal, to co
pe with them will be very difficult.Try also steam the skin, then clean the mounting foam abrasives - brush with stiff bristles, loofah, pumice stone or emery paper.This aggressive method, but in most cases the only possible.Proceed with caution, careful not to damage the epidermis.
find in the department of household chemical spray cleaner for foam and wipes-treaters.Carefully read the instructions on the package.Some tools developed to remove uncured building material may be used for cleaning various surfaces, including those for clothing and hands.Look for the appropriate manufacturer's mark!Some cleaners (especially more aggressive to hardened foam) applied to the skin is not recommended.
sure to lubricate your hands after cleaning polyurethane foam means any nourishing cream, visceral fat or vegetable oil.Mechanical cleaning - a lot of stress for the skin, so try to be careful to continue to work with assembly foam.
Work with Foam cleaner only in well-ventilated area, eye protection goggles.If you Spray the room, in any case, do not smoke or light a fire.
to oberech hands of foam, before the construction works are put on special protective hydrophilic cream.It forms a film that protects the upper layers of the epidermis of the polyurethane mass.Clutch operating contamination with the skin is reduced, which simplifies subsequent purification hands.
- Polyurethane foam and its use
- how to clean away with mounting foam