you need
  • - serpyanka;
  • - scissors;
  • - knife;
  • - putty;
  • - adhesive (bustilat, PVA, acrylate, etc.);
  • - spatula;
  • - sandpaper;
  • - primer.
Guide
1
Prepare the surface for reinforcement, thoroughly clean it from dirt and dust, degrease, remove blemishes and irregularities.If necessary, sand the coating and remove dilapidated (old paint, wallpaper, etc.) mechanically.If the surface is smooth, prime with it to improve the setting.
2
Zashpatlyuyte or seal the leveling compound (glue, plaster, cement) cracks, pores, seams, corners or other defects that are subject serpyanka seal.Dry and Scuff after drying.
3
Put in place sealing the adhesive layer (bustilat, PVA, acrylate, etc.) or liquid putty with a bru
sh or roller.
4
serpyanka Cut a piece of the desired size and stick it on the treated area.Smooth out the material with a spatula or a large brush-maklovitsej.
5
For a more reliable setting serpyanku soak in a dilute glue (8 or 9 pieces of glue, the rest - water).
6
for caulking plasterboard serpyanku stick without glue.To do this, dilute putty until thick sour cream without lumps and put it on the seam.Then carefully attach the severed tape serpyanka to the seam and press it into the applied layer so that it is completely soaked.Please note that it is not necessary to paste over so large a surface coating can not provide sufficient reliability.
7
After serpyanka will take its place and dries completely zashpatlyuyte surface.Recruited spatula small amount of material and apply it on the seam smooth movements, without applying much effort.Keep the spatula so that the angle between the inner surface and the plane of the spatula was sharp as possible to blend uniformly superimposed and not pressed into the seam.
8
dry for the time specified on the package with putty, sand the.The resulting bulge on the surface of the next day, remove the sandpaper.Apply primer and surface finish - Paint, wallpaper paste over, etc.