- - putty;
- - level;
- - trowel;
- - spatula;
- - masking tape;
- - brushes;
- - trowel;
- - sponge;
- - pencil;
- - acrylic-blue with glitter.
Perform marking walls, clearly limiting the working surface.In line marking stick masking tape.
Stir plaster: it must obtain a paste.Then, using a trowel, apply an even layer of plaster on the wall (approximately layer must be half a centimeter) and gently flatten it.
Make horizontal joints, using a builder's level or rail.The interval between the seams of the simulated stone easy to calculate: it corresponds to the width of the trowel.
Short edge trowel do the vertical seams.To do this, place the trowel at an angle relative to the wall and gently pressed into the soft (not cured) layer of putty.
to mimic the texture of natu
ral stone use a sponge: the result carried out intensive blotting movements putty acquire similar to the stone surface appearance.
Additionally circle all seams pencil.Do not make joints perfectly straight: this will create a feeling of unreality, because the seams when laying natural stone obtained is not entirely smooth.
Otderite masking tape on the wall.
When the putty dries, paint the surface of the acrylic azure light oak color and let dry.Then apply a second coat of paint (white acrylic glaze) and partial erase.After that, thin brush paint over the seams with light gray paint.Allow your creativity to dry up.
Do not try to do the same stones: in nature, they may be slightly different to each other.
To create the visual effect of cracking on simulated stones, use a pen.To do this, dip the sharp end of the pen in the ink color of your choice, leaning against the wall pen and gently rotate it between the thumb and forefinger.With the pen, you can create a crack of any width.
- How to repair a new apartment in ethnic style