you need
  • - pot;
  • - ground;
  • - sand;
  • - water;
  • - drainage;
  • - Bank;
  • - agent with phytohormones.
Guide
1
Carefully cut a small section from the top of dracaena.Pour into a jar of water at room temperature, and sprinkle a little to the bottom of sand.Place the container in the process.Monitor the state flower: after a certain time to appear roots.
2
If the process is good enough and strong, try to give it to take root in moist sand.For this process it under a special solution with phytohormones and dropped into the wet sand.As a primer, you can buy ready-mix in a flower shop.The capacity of the sand should be a little heated from below.
3
Wait until the stem cuttings of Dracaena formed 6-7 cm long. You can carefully separate them and repl
ant in the ground.Choose not too big a pot as an excessive amount of soil can lead to the death of roots.
4
transplant If you are already entrenched dratsenu, take the pot corresponding to the size of the plant.At the bottom pour drain, then fill the pot halfway with soil.Gently place dratsenu inside, taking care not to damage the roots.Add the rest of the soil.Try to strengthen the soil around the roots tightly enough to hold well dracaena.The rest of the land leave loose.
5
If you have already established process basically pot to transplant it, he will get stronger enough.To do this, remove from the pot and dratsenu try to find the roots of the border between the two plants.Gradually remove the ground on this border, and then disconnect the roots.