you need
  • - a sheet of paper;
  • - simple pencil;
  • - watercolor paints;
  • - Brush;
  • - set of postcards devoted to space exploration;
Guide
1
Determine what position you will draw rocket .If it is just getting ready to start, the sheet is better to put vertically.For the image of a flying missile may at any position of the sheet.Paper with better pre-toned.The cosmos may be any ink, but think again, what color will rocket.If it is bright, the sky may be bright or black.Bright rocket paint on black or vice versa, pale background.
2
Mark the direction of the rocket center line.If your rocket just getting ready to start, it will be enough only the vertical centerline.If the rocket flies, draw perpendiculars to the axis in both directions in its lowest point.From this point aside up and down a distance approximately equal to 1/4 the length of the perpendicular and put the point.Connect the ends of the perpendicular and the point of the oval.
3
perpendicular from the end up spend lines parallel to the centerline, approximately 2/3 of the height of the rocket.Connect the ends of these lines with the upper end of the axial straight.In line need not be carried out, the line should be soft.
4
Draw stabilizers.To this end each of the perpendicular lines plotted on the missile side a height equal to about 1/3 of its height.Put points on the sidelines a little higher and run perpendicular to both sides of straight lines, equal to about half the length of the perpendicular.Connect the points obtained with the point marking one third of the lateral line of the rocket.On the sides of the triangle to get 2 identical.
5
Draw a third stabilizer.Put one point on the centerline just above the lowest point, and the second - at a height equal to 1/3 of the height of the rocket.At either side of these points, draw a short equal segments by connecting the ends of the straight lines.You should have a long, but very narrow rectangle.
6
Above average stabilizer can draw one or two portholes.It's just a circle of any size, located on the center line.If there are several, the distance between them must be equal.
7
Paint rocket .Apply a thin coat of paint, capturing side stabilizers.Illuminators is not paint over.The second thin layer is applied, leaving the middle of the strip.The third layer, apply only to the side body of the rocket.Paint the windows in any other color.