First of all, check Keychain from all sides and remove the dust particles and dirt.Turn it back to his side and look at the small rubber plug panel protecting Keychain from minor injuries.
carefully, trying not to catch anything extra and do not scratch the surface, remove it from the body.Right behind it you will see a small screw, securing the upper and lower part of the body.Unscrew the screw with a Phillips screwdriver and put it in a small container to be inadvertently lost.
In that case, instead of caps you see a small icon with special rings, remove the screw that holds them, and
accurate movement of the rings disconnect, and then disconnect icon.
Treat keychain internal parts carefully, as all connections and connectors are very fragile, they are easily damaged.After troubleshooting fix two boards together, treating one of the side surfaces of the hot melt.
Install housing in its place and tighten screw neat movement.Then attach the cover.If you are good key icon, the first secure it in place, then attach the two rings and tighten screw them.
Check Keychain alarm of operation.If the problem persists, try to disassemble key again, or take it to a service where it will look and repair qualified specialist.
Tip 2: How to disassemble Keychain Sherkan
one of the best security systems on the car are signaling Sher Khan.This system has two-way communication and is a computer designed by the CPU.As the processor acts as a small and very comfortable keychain pager.Some owners in the long operation there are various problems with the remote control.To establish the extent of his problem and understand what kind of a problem, you need to stick it out.
- - cloth;
- - Phillips screwdriver;
- - hotmelt.
Take a stick in his hands and turn it over so that the opposite side was in front of you.Locate on the stick small rubber plug mounted in the device.It protects the body from various injuries.
Trim movement of the hand to remove it from your accessory.Immediately after this component, you will see a small screw.Remove it with a conventional Phillips screwdriver.Now the key is fully dismantled and you can see his "insides".Some other models instead of the plug is a special icon with small rings which are secured with a screw.In this case, unscrew it, remove the ring and remove the icon.
Examine closely the two boards inside.Sometimes, to solve the problem, it is enough to weld them together.Be careful with them in circulation, since the connection sockets are very fragile.
Connect the board to each other and fix the result.For this process the lateral surface melting.Apply a thin even layer, and remove the excess tissue.
In more serious injuries need to replace crystal element.This can be done by yourself, but it is best to consult a qualified specialist, who will eliminate the problems and answer all your questions.
Upon completion of the internal parts with remote control, carefully attach the body to the place, slowly insert the screw and screw it back.Install the plug carefully secure it and check the key to his performance.
to a keychain Sher Khan emerges as less of a problem, you can contact him as soon as possible care.Do not leave it in the cold and do not let it out of direct sunlight, do not drop and make sure that it does not touch the water.If possible, wear a key separately from the other keys, because of their very scratched screen and cabinet.
you had as little as possible to disassemble the key, follow the simple rules of operation, and then your key ring will last you much longer.Be sure to avoid getting water on the surface of the housing and internal parts accessories and do not expose to sunlight the screen keychain.If possible, do not carry key with other keys, as they may scratch the surface of the screen and the housing.