most popular items aerodynamic body kit and - a bumper, rear wing spoiler, wheel arch moldings on and rapids.Bumpers - most cumbersome, time-consuming and intricate details.After completing the manufacture of aerodynamic bumper independently on the same technology can be made, and all other details and kit.
From sheets of foam glue model of the future of the bumper.Consider all the aerodynamic features of future parts, namely the direction of air flow to the radiator and front brakes.In this need both thick and thin foam sheets.Cut the foam with a hacksaw or a powerful soldering iron with a shaped tip of a thin sheet.Sheets bond the PVA glue.
By removing the old bumper determin
e the new point of attachment.Of 2 mm sheet metal cut new mounting brackets, drill holes in them, and prime the dye.
form-cut foam blank attach it to the vehicle.If you wish to modify the design.Check the mounting points of the bumper of the future.Remove the excess.Cut holes for supplying air to the front brakes, extra recess and fog lamps.
fiberglass Cut into strips the width of 5-7 cm and a length of 40-50 cm. Each piece of plexiglass or spreads on the linoleum, and put on a epoxy resin.After soaking, the foam is glued to the shape of the bumper.Fiberglass stick in several thin layers.In one strip joints attach to another 1-1.5 cm. After the inner layer thickness of 2-3 mm Lay a metal mesh for reinforcement.Be particularly careful to strengthen the mounting points of the bumper.
Fat bumper mounting brackets welded to the reinforcing wire.Then, the wire is applied over the outer layer of glass, 6 mm thick in three layers.These layers are made very carefully, without bubbles and other blemishes.Thoroughly impregnated with epoxy fiberglass good fix brackets.The epoxy resin impregnation, add the last layer of paint to cover up scratches.
After drying and curing of the resin sand the bumper.Perform this operation carefully.If necessary, seal the desired portions with an additional layer of fiberglass.Then draw a final sanding with fine sandpaper.
priming before painting, do not use.Staining spend using the gun or aerosol cans.Drying painted parts are made with the use of an infrared lamp (heater).
- how to make yourself kit