Tip 1: How to start the car VAZ

to start the engine in cold weather sometimes you have to try.The winter season is often a real challenge for both car and driver.

main cause difficulty starting the engine, as a rule, is not sufficiently charged battery.But sometimes there are other reasons, which can be safely attributed substandard oil and fuel.Unfortunately, these factors are detected too late.And it is in those moments when you need to urgently somewhere to go.
you need
  • ether.
Guide
1
Prepare for the morning launch of the motor in the winter season must be the previous evening.When parking the vehicle, and the more open-ended, before turning off the ignition, press the accelerator pedal and increase within a few seconds the engine speed to three or four thousand, and then abruptly turn the ignition key to the "0".
2
morning came to the parking lot, do not rush immediately to start the engine.Before starting the engine for a few minutes, turn on the headlights.This action will warm the electrolyte in the batt
ery, resulting in easier starting.
3
After turning off the headlights, insert and turn the key in the ignition, wait for the automatic shutdown of the fuel pump, and only then try to start the engine, hold the key work of the starter for 20 seconds.If the machine fails to start on the first attempt, it is necessary to make minute break, and then again try to start the engine.For a successful start of the morning in cold weather a vehicle is required to carry out, as a rule, no more than three attempts.

Tip 2: How to create WHA keyless ignition

This motorist is able not only to drive the car to perfection, but also to find a way out of any situation.For example, make WHA , if the ignition key appeared lost.The main thing is to be able to get into the interior of the car.
How to create WHA keyless ignition
you need
  • Screwdriver.
Guide
1
Open the hood of the car.On the battery, remove the wire from the plug "plus".
2
Go back to the salon.Set the gearshift lever to the neutral position.Phillips screwdriver Remove the steering column cover.
3
Remove the bundle of wires to the ignition lock .Locate the red wire and move it to the side.The rest of the connect so that they kontachit together.Attach the resulting twist, such as a paper clip.At this point, all the equipment starts to work the machine.
4
Pull out the choke control of the carburettor in common - "leak."Place the machine on a manual brake and clutch pedal.
5
attach the red wire to the wire that you previously joined together.There will start the machine.Remove red wire from twisting.When stable operation of the engine after starting slowly release the clutch pedal and gradually, with increasing engine speed, sinking the choke control of the carburettor.
Note
Do not attempt to start the movement.When you try to start work on the steering lock machine.
Helpful Hint
Not all VAZ ignition wire connectors are the same.Some models have a connector / block to which the wires are removed with an awl.Only then they can be joined together, except the red wire.If you start your car without removing the wire from the battery terminals, when twisting wires ignition can occur unauthorized starting of the engine and short-circuiting.After starting the car immediately remove the red wire from twisting.Otherwise fails starter.

0
0