you need
  • - exterior paint;
  • - primer;
  • - a wooden bar;
  • - paint roller;
  • - Brush;
  • - putty;
  • - spatula;
  • - chalky talker.
Guide
1
If the surface that needs painting, paint already have, make sure it is not cracked, and the new coat of paint does not dissolve an existing one, and starts to crumble.To do this, apply a small amount of new paint on the old one.If within 30-40 minutes, nothing will change, you can start painting.Otherwise, the old coating will need to be removed completely.
2
new or refined base check on the readiness for painting, spending it on a piece of wood.The surface is ready, if there were traces of wood shavings.Zashpatlyuyte all cracked, chipped and holes in the plaster.After drying the solution, clean the surface with a brush.
3
Challenge base on absorbency.To do this, share it with a damp sponge.If the water is absorbed by the active wall, prime the surface.For treatment of highly porous and fragile facade surface using a primer of deep penetration.For a surface with fine irregularities and minor defects choose filled primer, filling and stabilizing the surface layer.
4
Those portions of the facade, which do not need to be painted, for example, lined with tiles, cover the chalk mash.This will facilitate the removal of random spray paint.
5
facade Divide into equal portions of labor input.Their boundaries often defined along the lines of ledges and pilasters, and on the smooth facades - fixing downpipes lines.Staining pass roll on a flat surface up and down or back and forth.Bands of paint must be superimposed on one another at 4-5 mm.To paint the interior angles, use a brush.
6
painting the walls in a single layer, first apply the paint horizontally.Covering so the first section dedicated entirely, blend the paint vertically.Painting the facade in two layers, the first layer is applied horizontally, second - vertically.When painting three-layer first and third apply vertical and the second layer - horizontal.
7
After painting the first section does not wait for drying the edges, and immediately proceed to the next coloring.This will improve the coverage of material and avoid the appearance of seams.