Tip 1: How to put the memory module

modules RAM memory directly affect the performance of your computer.All the necessary information, the CPU receives directly from main memory .
you need
  • program Speccy.
Guide
1
to connect new modules memory need to comply with certain conditions.First select the card themselves.To do this, determine their type, read the instructions to the motherboard.To do this, use the paper version or visit the manufacturer of the device.Find out the type of motherboard RAM works with your motherboard.If you can not find the right information, then install Speccy, downloading it from the site www.piriform.com.
2
Run this utility and go to "Memory."Find out the type of card used.This can be DDR or DIMM modules (1,2 or 3).Be sure to check the amount of memory installed boards and clock speed of their work.Specify the number of free slots for memory modules .All this information you can get with an application Speccy.
3
Get new modules RAM memory .If you decide to replace RAM card,
buy a set of identical cards.This will improve their performance in the event that the motherboard supports dual-channel memory operation.
4
Turn off the computer.Be sure to unplug the power cord from the system unit.Remove the old memory modules , if necessary.Connect the new memory board .If you are using a pair of modules, then install them in specific slots.They are usually painted in a certain color.
5
Turn on the computer and check the installed modules.To do this, open the Control Panel and go to the "Administration".Click on the icon "Check memory Windows».Confirm the restart your computer and wait for the check the status of memory cards.If during the first boot will be error BSoD, disconnect all modules.Insert them one by one, each time turning off the PC.Most likely, the error is not in the cards themselves and in their original joint determination.

Tip 2: How to add a memory module

limited to the personal computer user whose interests are limited to the use of office software and video games, the installation of new components in the system unit seem mystical operation.In fact, nothing complicated about it.The motherboard has a connector corresponding to each element.By and large, it is much more difficult to rebuild the proper operation of the device than to connect it.
How to add a memory module
you need
  • - Phillips screwdriver.
Guide
1
Unplug your PC from the power supply.Disconnect the system unit of the devices and install it at the place where it will be convenient to install the memory module.Remove the side cover.To do this, use a screwdriver to remove the screws holding it fixing.Generally, there are two.Inspect the motherboard.Find it on the connector corresponding to the memory module.In other words, get a similar fee has already been installed in the slot.Nearby is sure to be one or two free ports.With their discovery problems should arise.
2
Remove the old memory module, if necessary.If you decide to add a memory module, install it to a nearby port.If the old unit is still required to remove, get special latches located on each side of the memory module installed.Take them down.Confuse you can not, because these elements are able to move only two directions, of which currently only one available to you.Once the latch will be set aside, remove the memory card by pulling it toward you.Problems with extraction should arise.
3 Insert the memory module in the free port.Lower the latch to lock the memory module into the motherboard.Normally, when the latch is automatically triggered.For this to happen, gently push the unit during installation.Once the installation procedure is successfully performed, attach the side panel of the system unit in place, connect the all disconnected device and start the computer.The memory module is detected in the process of loading the operating system.The volume of RAM will be reflected on the first page load.If you have not noticed, there is another way to check it.Right-click on the icon "My Computer".In the window that appears among the parameters of the system will display the amount of RAM.If he does not change, then you have recorded bad memory.Do the above operation again.
Sources:
  • how to put the memory

0
0