Tip 1: How to connect Hub

To expand the local network or combine multiple subnets in a single use of the AC hubs .To avoid problems in the new network, you must correctly configure and connect the equipment.
you need
  • - network cables.
Guide
1
To begin, select a network hub.In this note total number of ports for connection of network devices, as well as the possibility of adjustment.Better to choose a network hub, whose number of LAN-ports will be more than required at the moment.
2
Purchase a suitable device.Set it to the desired location.Note that it is necessary to connect the network cables, and possibly, the device will heat up during operation.Connect the hub to the mains and turn it on.
3
Connect using a network cable the equipment with similar devices on the LAN.If you want to create a new network, and not to increase the existing, connect to a network hub required laptops and computers.
4
In order for the process of networking computers are not to be confused, it is recommended to se
t a static IP-address.This method also allows to connect the PC to some printers or the like.Open the Control Panel.Go to "Network and Internet".
5
Click on 'Control Center Network and Sharing Center. "Go to "Change adapter settings".Right-click on the network connection you want to configure, and open its properties.
6
Highlight "Internet Protocol TCP / IPv4ยป and click "Properties".Activate the option "Use the following IP-address".Fill in the required items in this menu.Within a single network is better to use IP-addresses, which are identical to the first, second and third segments.
7
In that case, if there is a local network router, the router or modem, enter in the field "Preferred DNS-server" and "main" gateway of its IP-address to gain access to the Internet.

Tip 2: How to connect a hub to a hub

Sometimes there are situations when the network expansion is necessary to use additional equipment.In such cases it is advisable to resort to installing a network hub, or hub .
How to connect the hub to the hub
you need
  • network hub (HUB), the network cables.
Guide
1
To begin select the correct hub.If you do not need a special way to configure the routing within the network, get a regular network hub with nenastraivaemymi ports.
2
Install the equipment in place.Connect the power supply to it.Please note that it is not necessary to buy the cheapest model in the concentrators if it will be connected to a large number of computers.In this case, you risk severe loss of data transfer speed.
3
Select the second hub, to which you will connect the new device.If there are no free slots Ethernet (LAN), then unplug the one device.We recommend turning off the computer, which is less demand on the network.
4
Connect to port to release the new hub, using a network cable.If you have a need to connect the hub to another hub, remember one rule: never connect these devices ring.IeAvoid pairing three hubs, even if it will be a few related devices.
5
Connect the previously disconnected the computer with the new network hub.Connect this device to the other required computers, laptops and printers.
6
Configure the network adapters of new equipment in such a way as to conform to the requirements of the existing network.
7
If you purchased a hub port will be set, then perform these settings so that all computers can access the network without creating conflicts of IP-addresses.
Helpful Hint
not install the Hub too far from the main cluster of computers.This will result in an unnecessary waste of network cables, and to the loss of the data rate.
Sources:
  • how to set up a hub
Helpful Hint
not install the hub too far from the main cluster of computers.This will increase your cost of network cables and reduce the speed of the network.

0
0