- - detergent;
- - a small knife;
- - Abrasive;
- - solvent;
- - primer;
- - special gun or syringe to paint;
- - wet cloth;
- - paint;
- - lacquer.
Prepare the desired part of the bumper well.Remove from scratches dust and dirt and be sure to wash it off any detergent or an ordinary detergent.
gently with a knife, clean the damage from peeling paint.Then sand the scratches using a special skins.Once the surface of the bumper and matt, clean it with a special degreasing solvent to remove any residual tar.
Cover scratched part bumper and two layers of primer.To facilitate the process, it is best to use a special gun.Initially, evenly apply
one coat, let it dry and then repeat the procedure.
Wait until the soil dries out thoroughly, it usually takes about two days.Primed special sandpaper to eliminate defects and irregularities on bumper e. Do not overdo it, otherwise you rub it all to the ground.Once you otshlifuete primer Blow it carefully and degrease.
Before applying the paint, wipe the surface with a slightly damp cloth.Tinted bumper possible by means of the usual small brush or special tool in the form of a syringe.Spread a thin even layer paint and wait about twenty minutes to make it dried up.Then gently apply the dye and wait for it to re-drying.If you find that the result does not suit you, you can apply one or two additional layers.
Secure the result obtained with varnish.It is best applied in several layers, too.
recommended during all work to close the rest of the film so that they do not stain.Before the start of the process is to take care of the room, cover the floor with newspapers and then it will not get paint and debris.