Tip 1: To adjust the injector

At present, almost all new cars are fuel-injected engine.He needs constant supervision.The injector must be able to properly regulate.Only in this case it will work optimally.
Guide
1
to start pay attention to the connection elements of the system.Then turn on the mass and ignition.On the instrument panel should light up briefly Lama malfunction.The electric at the moment is to pump gasoline.It takes about 5 seconds.Make troubleshooting, if they are available.If the fault is not present, you can move on to further verification.Note the engine is not recommended to run to eliminate the failures.
2
If there is no communication with the control unit and lamp failure is not lit, check the main relays and fuses BCF 10A and 20A.If it does not turn elektrobenzonasos then first check the serviceability of the relay responsible for it.Also worth checking out a weight wire.
3
Then can proceed to the verification of the throttle device.The first good look around the wire itself throttle posi
tion sensor.Turn on mass and ignition.With the tester determine the degree of throttle opening, voltage throttle position sensor and voltage in the wiring.
4
These parameters compare with the reference: the degree of throttle opening 0-1%, voltage throttle position sensor should be 0.25 - 0,65V, System voltage over 12V.Adjust the throttle actuator so as to completely cover flap.Press the accelerator pedal up to the stop.Measure parameters in this position.The degree of opening of the throttle must be more than 90%, voltage throttle position sensor 3.9 - 4,65V.Adjust the drive to full throttle opening.
5
Then disconnect the regulator of additional air from the harness.If a hot engine can easily start, it is recommended to perform a sucking air through half-closed throttle.Drive to adjust the throttle so that it completely covers the opening.

Tip 2: How to adjust the plow

The complex of measures for farming in the proportion of plowing plow with account for nearly half the total volume of work.In turn, the quality of these operations depends on how prepared and adjusted plow.
How to adjust the plow
Guide
1
Begin adjustment with the working parts of the tool.The main working element of the plow - share, accounting for more than half of the load during plowing.Ploughshare must be properly sharpened.Otherwise, its performance may drop by nearly 20%, fuel consumption increases by 20%, and the depth of treatment - more than a third.
2
most important requirement to plowshares - their blades must be fusing of the carbide cutting edge up to 1 mm, with an angle of from 25 to 400. All the coulter should be the same size.Tolerances on the length of the blade, the length and width of the backrest are respectively 15, 10 and 5 mm.Make sure that all the screw heads are flush or were drowned and 1 mm.At the junction of the blade and coulter gap should not exceed a millimeter, and the blade should protrude more than 2 mm.
3
It is important that blades and share from the field are on the same line.Permissible protrusion of plowshares Blade - no more than half a centimeter.It is not allowed to strut housing advocated Field ploughshare and the blade edge.Possible gaps between the shingles and the bar and between the blade and the counter - 3 and 6 mm, respectively.
4
Check landside on the plow, which should be smooth, with their back is aligned with edged plowshare.Tolerance can not exceed half a centimeter.
5
coulter blade set parallel to the installation site at the back of the allowable elevation of less than a centimeter.Do not tilt the frame and installing bent gryadiley.All this violates the right general location of the body of the plow .The correctness of plowshares installation you can check by pulling on the cord toe and heel of the front and rear housings.Tolerance socks and heels by stretched cord can not exceed plus or minus
Sources:
  • how to set up the plow

0
0