- - wrenches;
- - Screwdriver;
- - carpenter's knife.
To replace the belt put the car on a viewing hole or overpass.With the key 10 to loosen the four bolts on the pulley pump coolant.Then you can remove the belt itself and auxiliary parts - drives a generator, air conditioning compressor and power steering pump.
Next completely unscrew the bolts and remove the top cover.Using key 22, loosen the bolts that hold the crankshaft pulley.If you have a car with a manual transmission, you have someone to hold the brake pedal with gear to turn the crankshaft.
Install the piston at top dead center by turning the crankshaft until the match is not marked with the letter "T".When the mark on the c
amshaft bearing aligns with the hole in the camshaft sprocket, loosen the bolt, remove the crankshaft pulley washer and a protective cover.
key 10, loosen the bolts of the lower cover, and the key 12 loosen the adjusting screws and bolts.Then, thrusting a screwdriver between the roller and the sleeve, turn all the way counter-clockwise tensioning pulley bracket and loosen the belt tension and then tighten the adjusting bolt.
Then use a screwdriver to print because of the case of the oil pump end of the spring, loosen the bracket mounting bolt and carefully remove the tension roller.When replacing the support roller also need to key in the 12. Remove the bolt and remove the clip.
installation in the reverse order.Before you install the belt, be sure to check that the mark on the camshaft and crankshaft coincide.Now install the belt on the crankshaft pulley on the camshaft in such a way that the part of the support roller belt is tensioned.
Then loosen the bracket mounting bolt tensioning pulley and the adjustment bolt.During this operation, the roller locks in the working position and belt tension will acquire.Rotate the crankshaft twice in a clockwise direction using the pulley fixing bolt.
- how to change the timing on Hyundai